Mend Bosch Logixx 8 Washing Machines

Mend Household Appliances, Washing Machines

Find out how to mend it for free.

Ask Question

Click here to mend Bosch Logixx 8 washing machines

Mend washing machines ...

Mend Washing Machines

Mend > Washing Machines

Mend Bosch Logixx 8 Washing Machine Fault

What is Error F43 on a bosch logixx 8 washing machine?

Stuart Broadbent
January 2011

Bosch Bosch Logixx 8 Household Appliances, Washing Machines Washing Machine Bosch Fault

Love you guys thanks so much saved me a fortune am due to have baby in five weeks so didnt need added expense of a new washing machine . Gotta love the internet xxxxx

sonya
October 2017

Thank you Jon. These instructions helped me. Washing machine had stuck with a load of washing inside.

Fi
March 2017

I followed Jon Page's instructions from November 2011 and it worked.

Thank you very much, saved me a fortune.

Audrey, Edinburgh
December 2015

In australia my logic washing machine to clear error code is Put dial to spin, hold left options key, turn dial to drain, release left options key. Your machine should reset it self. My F43 error also turned out to be the bushes worn.

Simon
September 2015

Brushes on mine were worn to less than 1/2 inch.
Replaced and cleaned the black soot from the worn brushes.
Runs great now.
Thanks

Golf nut
January 2015

Jon Page thank you...you saved me today😄

Orla
January 2015

there is no spin button to press and hold

Marcus Rose
September 2014

motor brushes /hall sensor /associated wiring /control module
after any repair to the above do a reset as outlined perfectly in the post above

moonraker2
September 2014

The F43 error code by the Bosch washing machine answer from Jon Page is perfect. I followed it and got immediate results in less than 5 secs. cheers Jon.

Craig
August 2014

motor defect

jduith
May 2014

Motor or Circuit Board Fault. Try resetting circuit board first - knob to off (12 oclock), then down (6 oclock), press and hold spin, round to 9 oclock, wait 5 secs, release spin, knob to 12 oclock. should be reset.
If it doesnt work investigate wiring\board\motor.

Jon Page
November 2011