Garden Tools, Chainsaws

PCN Ryobi on continuous high rev - Not caused by idle screw?

My Ryobi PCN 4545 18" petrol chainsaw continues to run on high rev upon starting. The idle screw is backed all... [Read more]

How do you recoil the spring for the rope on a Poulan?

On a Poulan chainsaw Mod.P4018WTL we need to recoil the spring and cannot find a point to wind it up.Can u te... [Read more]

mculloch titan 50 fuel and oil line replacement?

I am trying to find the oil and fuel line diagram for a mculloch titan 50 chainsaw the lines were rotted out a... [Read more]

Hegde trimmer?

my flymo hedge trimmer blades are stuck.I cut a branch (it was a bit too thick) now the cutters will not slide... [Read more]

where can i get a ac-dc charger for a parkside hedgetrimmer model num 41503?

model num 41503792 charger parkside

Rewinding recoil starter?

I had to replace the rope on the starter of my Homelite Yarkvark blower and I accidentally unwound the recoil ... [Read more]

how to change primer bulb?

how do you change a primer bulb on a spear and jackson chainsaw

craftsman 16' chaio carb lines go. The old ones all crumbled. ?

My craftsman chainsaw needs all the carb lines replaced.The old ones broke off. I have no idea where the repla... [Read more]

how do i remove and replace bell housing on a craftsman chainsaw ?

how do i remove and replace bell housing on a craftsman chainsaw?does it screw off or do i need special tools?

hb180?

where can i find a new carb for my homelite hb180? near florissant mo. thanks

reinstall rotor pulley, craftsman chainsaw, mod 358.356090, ser B2933317?

my last new rotor pulley was installed, and chainsaw used once. It started and ran. The new rotor pulley gea... [Read more]

McCulloch mac5 40e chainsaw?

need a photo of where wire goes that is attached to choke button on mac5 40e chainsaw.

plate compactor fault?

I have a plate compactor that has stopped moving forwards, I have stripped the excentric shaft out and cleaned... [Read more]

my pcn 4545 not feeding oil to bar and chain?

i have a pcn 4545 and its not lubricating the bar and chain , has any one else experienced this and do u know ... [Read more]

ghd? hair starters?

how can i rewire them

what bandsaw blades are best for power craft bandsaw?

where do i buy bansaw blades for power craft bandsaw and could some one advise on setup

mcculoch/mac bc 433l garden strimmer?

fuel mixture ratio for above machine

power tools?

do you know of a parts out let for power craft chainsaws thanks

where do i get parts for a power craft chainsaw?

I require parts for a power craft chainsaw

chainsaw- homelite super2?

I'm looking for a manual for a homelite super 2. Do you know where I can get one