Garden Tools, Lawn Mowers

My John Deere L130 is not pulling as hard as it use to?

The drive seems to be slipping is it a belt or pully I could change or do I have to bring it into John Deere?

whats wrong with my recoil starter?

when I pull the starter cord nothing engages to turn the engine over. it would seem that the pawls that locate... [Read more]

i need a diagram to replace the spring of a lawnmower?

I have a briggs and stratton 300 series push mower. My son tried to replace the string, but the spring came o... [Read more]

Why does my belt on my Craftsman mower pop off when I engage the blades?

My Craftsman model 917.271020 mowers belt pops off every time I engage the blades. The pulleys are routed corr... [Read more]

Murray 12/38 seruois help needed?

I NEED HELP!!! I purchased a Murray 12/38 or 40702x92e model #'s. it doesn't have a deck. it has upgraded ... [Read more]

How to replace Victa mower starter cord (Bronco)?

I have the starter cord but its not winding on properly, how to wind it on so it recoils after pulling?

starts hard and has no power?

john deere stk38 12.5 kohler engine

do you have a diagram for this?

wont start by switch wont shut off by switch

where is?

where is oil plug on kohler engin 12.5, john deere lawn rideing lawn mower?

what size is the belt that goes in the middle ?

I have a 2004 46 inch huskee riding mower and it holds three belts the upper belt the middle and the lower dec... [Read more]

13 horse power?

i have a 13 horsepower briggs & stratton motor when you try and start it it tuns over real fast then it backfi... [Read more]

how tight is the nut that holds the brake acuateron crafsman?

how tight should the acuater nut be on the brakes of crafsman tractor?

how do i tighten the spring on the starter cable to allow it to rewind?

how do i tighten the spring on the starter cable to enable it to recoil (problem occured after the cable broke... [Read more]

what oil is in the differntial?

what oil is used in the differential box in a snapper model no 25066s

petrol and air mix settings?

ive recently obtaind an old qualcast single cylinder lawn mower and can not get the right air and petrol mixtu... [Read more]

how to replace a drive belt?

how do I get instructions or a diagram on how to replace a drive belt on a John Deere 165 riding mower

where to find parts for scotts lawn equip?

have had mower since 1996 and belt has just now given out. am not finding anywhere that carries the replaceme... [Read more]

I have a Toro RWD Landscaper-1990 - It does not move!?

I have the rear wheel mechanism apart and it seems to be working except I do not understand how the individual... [Read more]

How do I set the springs in the right spot on my weed eater push mower? ?

I have a big problem my springs on my push mower must be wrong, and for some reason my push mower wants to idl... [Read more]

How do you remove a jackshaft from the pulley and mandrel? ?

I removed the 6 screws holding the mandrel on. I was wondering if this is a press fit or will I wreck somethin... [Read more]