How to mend ... Need Diagram Carb

looking for carb diagram for qualcast 35s?

just got second hand 35s which was non runner.cleaned carb but not too sure where linkage bar from carb to thr... [Read more]

replacing gas lines for weedeater model LT-17?

i bought new gas line for my weedaeter,but forgot how the lines hooked back up ,it has a primer bulb with two ... [Read more]

Mac335 fuel pipes?

I have a Mac335 in very good condition except that all the fuel lines have rotted away as it's not been used f... [Read more]

Lawnmower DIY?

I have a Quattro 40 Victa / Briggs & Stratton lawnmower. Whenever its running, it will rev up and down. I've b... [Read more]

How do you route a fuel line that has only one inlet in the carburetor?

I have a 1983 Craftman Poulan saw. The fuel line was rotted when I took it off. I can not figure out how to ro... [Read more]

B&S 3.5hp Quantum won't slow down?

My 3.5hp Briggs & Stratton starts fine, but I can't get it to run below maximum revs. The controls on top o... [Read more]

B & S Classic 35 Non start?

Cut out whilst under load and now will not re-start, tried cleaning plug and no issue with air filter or carb ... [Read more]

diagram to hook up two carb lines from tank and primer ball on mcculloch ea?

I purchased a used mcculloch eager beaver chainsaw...the primer ball was cracked and both lines were busted of... [Read more]

Need a breakdown on inside carb for Tecumseh LEV100-338020E?

I have been looking everywhere for a schematic of the inside carb of Tecumseh model LEV100-338020E! Have calle... [Read more]

fuel lines on Craftsman chain saw?

I have a Model 356.352161, 2.2 cu. in./2-cycle 16 inch chain saw. I tried using it to day and is started for a... [Read more]

fuel line replacement poulan wild thing?

The fuel lines were completely destroyed inside so I need a diagram as to which line goes into which hole whic... [Read more]

need carb diagram?

need a copy of the carb diagram for a 4 stroke troy bilt/mtd string trimmer. The model number is TB475SS.

Craftsman Eager-1?

I am looking for a photo,diagram, or picture of how the 2 springs are hooked to the carb. I also am seeking in... [Read more]

Where can i find a diagram for my Briggs and stratton model 281707 carb?

I am looking to rebuild the carburator on my Briggs and Stratton carburator but need a diagram to rebuild it. ... [Read more]

Pluming diagram for McCulloch 3200 Chainsaw?

I Have a McCulloch 3200 chainsaw whose fuel line just rotted out. I have the new fuel line but need to verify ... [Read more]

Linkage setup for Sears Eager 1 model 917.372470?

Hi, I am fixing my lawn mower. Cleaned carb and got it to run! Yeah. My problem is the linkage is wrong,... [Read more]

I need digram tecumseh 4.0 hp carburator rebuild?

I am rebuilding the carb on a snapper walk behind with a tecumseh 4.0 engine TVS 840-6011A-8041A and I am look... [Read more]

how can i fix the carberator rods?

i have a sears rear motor 8hp 30in cut the carb was replaced but the rods were left hanging is there a diagram... [Read more]

Carberator conections for Tecumseh engines?

I need a diagram of ALL cable ( throttle, choke and govenor) conections to the carb on the Tecumseh BVS143 eng... [Read more]

need diagram of snapper riding mower carb/fuel 12hp 1990+- Series 3,4,5-/+?

I am having problems where gas is leaking from my mower. The Fuel tank and filter and tubes are intact but the... [Read more]