How to mend ... Help Replaced Stays

POTTERTON PRIMA F ERRATIC FAILURE TO IGNITE?

When the hot water or heating is switched on the boiler attempts to start up, i.e. the fan starts and stays on... [Read more]

Boiler cycling - 10 seconds on 10 seconds off?

Myson apollo 30si, CH only, boiler thermostat on low, no room stat, radiator stat's on 4 radiators - 2 without... [Read more]

Eurocal oil fired boiler - HOT water for 60 seconds them only warm water?

Hi, I’m hoping you can offer some assistance with a 5 years old (Approx) Eurocal Oil-fired combi boiler ... [Read more]

Myson Apollo 50si?

Pilot light wasnt lighting so replaced the PCB. Now the pilot light stays on but the boiler doesn't kick in e... [Read more]

When we replace the toner, the toner light stays on,?

The toner needed to be replaced in the copier and we replaced it. Now the light stays on and we still can't ma... [Read more]

Halstead ace high burner problem?

I have a Halstead ace high combi boiler. I have replaced the diaphrams in the flow switch CH & DHW and removed... [Read more]

how to make hydro pump work belarus 250as?

i replaced the seal on the shaft for the pump engage and disengage reinstalled the access plate now pump stays... [Read more]

cannon fan oven wont heat?

Hi ive replaced the element in my fan oven but the tempreture light stays on continuously and the element wont... [Read more]

Very strange overflow dripping...please help!!?

Hi, Please can somebody help. We have two tanks in the loft, one large, one small. I am not sure what the sma... [Read more]

Kitchenaid KSSC48QKS02 fridge side is too cold?

had a problem with yet another kitchenaid product, this time our side by side refer. At first, the fridge sid... [Read more]

Weed Eater Primer bulb won't release?

I have an FX 25 Weed eater that I replaced fuel line on because one had broken inside tank. After replacemen... [Read more]

1999 saab ?

1999 saab 95...... just replaced motor and car wont start except when starting fluid is used......dash board c... [Read more]

kenwood a901a?

i have replaced blown pcb but cannot get mixer to slow down.it stays constant speed fast all the time thanks.

the tin of my breadmaker will not stay put?

For the first 10 minutes of so, the tin stays put, then it jumps up out of its holding. any clues. I'm on my s... [Read more]

stop warning light on and car wont start citreon xsara?

my stop warning light stays on and car will not start. i have checked my fuel, water and oil level and all fin... [Read more]

How to fix a dual flush toilet cistern cable?

Hi, I have a dual flush toilet cistern. When the push button is operated it stay down and does not come up. B... [Read more]

Help With Primer Bulb On Weed Eater Featherlight Trimmer?

Can anyone offer any explanation as to why I can't get the fuel tank to prime when I pump the primer bulb as n... [Read more]

Engine management light stays on?

...after fitting a new cat to an 02 Vectra sri150 estate - only replaced the front lambda, took the rear one o... [Read more]

Vallant TurboMax 828E?

My boiler which is 3 yrs old takes several mins before I get hot water from the tap. I have replaced the diver... [Read more]

unable to relight boiler?

my ideal mexico super boiler has a fault,,if i relight the piulot it stays lit until i release the gas control... [Read more]