How to mend ... Help Apart Removed

How can i replace lower door seal?

How do i replace lower door seal on electrolux esl6115 dishwasher...i have already removed the wooden facia an... [Read more]

removed egr sprayed throttle cleaner through manifold low revs and now wont?

mitsubishi 19 did diesel removed egr cleaned manifold with carb cleaner eml came on then low revs couldnt pul... [Read more]

Pressure problems with Optimax HE PLUS 38 C?

The pressure keeps rising even with the filling loop removed and blanked off. Can drain down to 1Bar and over ... [Read more]

How to fix flashing lint light on BOSCH WTMC6500?

The lint filter light flashes and dryer will not start. I have removed filter, cleaned with warm water and ... [Read more]

fridge/freezer hotpoint ffp187b?

My fridge/freezer is coming up to 7yrs old and we have recently noticed food has not been freezing correctly. ... [Read more]

how to repair my sony remote?sony slvn500?

remote work when bats, are removed and then re inserted

Error code 4 on Hoover AI130?

Hi, Can anyone help please? On my Hoover AI130 / AL130 Hoover Six 1300 Sportswear I got an Error Code 4. The... [Read more]

AL10 eror code on Hotpoint SDW80?

I have seen a few posts on this site on this topic but all of them (that I have seen) relate to the heater not... [Read more]

Sanitop Macerator failure?

The macerator was blocked by tough hand wipes but after clearing the motor 'hummed' but would only spin if it ... [Read more]

how do i change bearings on drum of my indesit wil163?

got new bearings for drum have taken off pulley wheel on back and have removed 8 screws from the red cross sec... [Read more]

instructions on how to replace the belt on a dejur 750 movie projector?

I have a dejur 750 movie projector which needs a new belt replacement. does anyone done this or have a diag... [Read more]

How can I fix my Dyson CR02 w/m which will not empty or start?

Serial no. L1524247-CR02 Dyson w/m has an unreadable digital control panal and after clearing a blockage in th... [Read more]

Stannah 400 stops working after a few inches?

My Stannah 400 has stopped working fully it starts to go up but then after a few inches it stops. If I turn of... [Read more]

My fridge freezer stopped working 2 days ago. It is a Bosch active no frost?

Hi My fridge freezer stopped working 2 days ago. It is a Bosch active no frost KSU45621AU/02. I have let ... [Read more]

boot lock fault?

the central locking on my 206 cc is not working, so I have been using key to unlock boot. Now however the key ... [Read more]

Sigma S30 - Immobilizer problem??

Hi Folks. I have a Sigma S30 fitted to my 1998 MX5 Mk2. I removed the Car battery as it was faulty and after... [Read more]

Can I remove support pillers?

I am starting a project to modernise my porch. the building is approx. 3mtrs long X 2.5mtrs wide. inside atta... [Read more]

How do I fit a new door spring onto my Proline DW12 machine?

I have removed the inner main door panel and bottom fascia and have found that the right-hand door spring has ... [Read more]

ecomax 828?

heating is on even when clock is off,I have even removed integral clock with four prongs that go into pcb and ... [Read more]

wiring diagram fot main oven switch zanussi modal no zcv561dx?

I am looking for a diagram of the wiring for the main oven switch as my son removed the old one and cannot fin... [Read more]