How to mend ... Fully Going Years

No Spin?

I have fully auto. Samsung WM. It is 3 years old. It worked perfectly. But now when it comes to spinning las... [Read more]

Controls and ceramic job removal?

something under the front of the hob has blown and shorted causing the fan to operate without the oven being s... [Read more]

bosch classix 6 1600 express?

the soft rinse drawer does not empty fully, and after the wash is finished, there is at least 3/4" ins of wate... [Read more]

I have a Hotpoint TDC60 and the filter is nearly always wet?

I have Hotpoint TDC60 tumble dryer with a consistently wet filter. I clean both the filters regulary (one in t... [Read more]

Frigidaire larder elite fridge no longer self defrosting properly?

Very helpful to share ozone answer to Gill Bowyer (November 2011). We followed your instructions fully. Defro... [Read more]

How can I fix my Drayton 30002/RF601Room Thermostat ?

The wheel of the above will not turn temperature down below 20 degrees having worked perfectly for two and a h... [Read more]

Ariston washer dryer A1400WD ?

My machine is over 5 years old but has worked fine until now.Machine will not spin fully in wash cycle. When i... [Read more]

57 vectra 1.9 cdti starting problem?

hi i have had a 57 vectra 1.9 cdti for nearly 3 years now and its been a pig to start all that time.from cold ... [Read more]

the water will not empty from the drum?

The water will not empty from the drum. I have used the emergency pipe to empty the water out and I have clea... [Read more]

new worcester 550I combi boler?

When the hot tap is opened fully the temp of the water increases until the boiler trips out .Worcester service... [Read more]

Galaxy g8000s shower not providing hot water?

We have the above shower fitted above my bath, this has been fitted roughly 10-13 years ago. This has worked f... [Read more]

I recently repaired a leak on a rad valve, ?

I recently repaired a leak on a rad valve, where some of the system was drained. The system is 0.7 bar cold an... [Read more]

How can I fix my Mira Electra Shower?

I have no water at all. I have checked water pressure is Ok, filter is OK, switch does click on and OFF, showe... [Read more]

Intermittent humidity sensor problem on Zanussi ZDE47100?

I have a Zanussi ZDE47100 sensor dryer, about 4-5 years old and for some time the sensor only seems to work in... [Read more]

Having cleaned my condenser unit it will now not go back into place?

Any ideas on why my condenser unit will not go back into its slot fully? All cleaned nothing appears to be blo... [Read more]

How start my rebuild 180 sp?

Hi ive had my engine rebuilt fully and now put back into the bike, now the main question why wont it start? Ba... [Read more]

stannah stair lift 300?

The power hinge rail at the bottom of the lift fails to fully lift up. The motor seems to struggle about half... [Read more]

Help, can i get it repaired?

I got my pathescope gem from The Real Camera Co, Manchester. Its beaufiful, but i got it more as collectors p... [Read more]

Humax slow pulling in programme guide?

My first 9200T was replaced (some 2-3 years ago) by John Lewis because the unit could not pull in the programm... [Read more]

Robin NB 411 starts only with choke closed thens dies?

I have been given a Robin NB 411 brushcutter unused for many years. It starts with choke closed then dies as I... [Read more]