How to mend Control

3

How can I fix my CEF AP28 Control Panel?

Other sensors in Zone 1 of my house alarm system will activate the alarm but one of the sensors, although lit,... [Read more]

4

How can i fix my house alarm a Melcom ST6100?

I have power supply to my alarm control panel but my alarm siren no longer goes off and my door connectors no ... [Read more]

2

Accenta8 mini help?

Right where do I begin?! I have an Accenta8 mini house alarm. My Dad accidently set off my alarm and didn't... [Read more]

1

Help with Veritas R8, tamper light and zone 2(Hallway)?

Help with Veritas R8, tamper light and zone 2(Hallway)? Help with Veritas R8, tamper light and zone 2 Can no... [Read more]

3

aegis home alarm?

Hi there.I have a AEGIS alarm system.on the control box there is flasing F4 & blipping noise.would youknow wha... [Read more]

1

C&k securitech 800L?

I had to open main box on alarm which has put tamper light on control panel I have entered my code and # as bo... [Read more]

1

can i replace a 6 volt bell box with a 12 volt bell box?

I have a itec horizon alarm but the bell has a 6 volt battery. I want to replace it with a 12 volt box would ... [Read more]

8

Anyone know where I can get replacement Scantronic 9800 control panel?

My control panel digits are really hard to push now after 16 years. Banham have told me that I need to replace... [Read more]

14

battery missing fault?

can anyone tell me how to get rid of a missing battery notice? i have a scantronic 816 control panel with a 91... [Read more]

10

Veritas alarm?

How can we reset our Veritas alarm after a power cut? The display shows 4 red zone lights and a tamper light i... [Read more]

4

How to change the code on the key pad?

I have a 9827 control pad, I would like to change the key pad number because the old number on the pads which ... [Read more]

Help with Veritas R8, tamper light and zone 2?

Help with Veritas R8, tamper light and zone 2 Can not reset the alarm using the correct code (it bleeps), fo... [Read more]

1

How to remove the tamper on the control panel on my scantronic 9450 unit?

I have a scantronic 9450.I have just replaced a door in my hallway and replaced the old door sensor into the n... [Read more]

1

replace optima xm6?

my optima xm6 control box is corroded. what can i replace it with, and about how much would a new box cost and... [Read more]

2

after replacing the control panel the alarm system has failed ?

i have a veritas alarm system, installed a new battery the key pad came on then instaled a new key pad and lo... [Read more]

3

accenta alarm?

Although everything appears to be working properly on the control panel has an intermitent alarm sound coming ... [Read more]

19

9800 bf fault?

Got home from work and an alarm was going off but only inside the house. The control panel was displaying b... [Read more]

2

how can i reset alarm?

i cut wire by mistake rejoin wire colour for colour outside alarm goes off inside control pannel dead

1

Accenta + alarm beeps very 6 minutes?

Hello can anyone advise me on how to stop my alarm from beeping every 6 mins. I have pressed chime & reset but... [Read more]

3

9561 Control panel bleeping intermitantly?

The control control panel on my system has started to bleep intermittantly and is displaying the following ins... [Read more]