How to mend ... Motor Trying Engine

Atco Admiral 16 lawnmower?

I have a Atco Admiral 16 lawnmower and the motor does not run at contiuous revs. it starts ok and will run all... [Read more]

hayter mower with B&S 375 engine, motor oscilates fast and slow?

The moter starts up OK, but after a few seconds the speed is no longer steady, but oscillates between fast and... [Read more]

mountford 1436m wont start?

When I try to start my sit on mountford mower (1436M) the engine wont start and there is a high pitched noise ... [Read more]

no compression?

honda motor cycle 125 xr stopped running, no compression when i turn engine over and finger on spark plug hole

Tecumseh/Murry Lawn Mower Engine Will Not Stay Running?

I have a problem with a Tecumseh 3.5 HP lawn mower motor. I would like to know the reasoning for replacing the... [Read more]

Murray 12.5hp rider with gas in oil?

Just bought a used Murray 40508x92a. It has been sitting for 2 yrs, garage kept. Its a 12.5hp Briggs and Str... [Read more]

keep shearing flywheel keyway?

BRIGGS & STRATTION MODEL 28N707 TYPE 0173-01 CODE 961022ZE firs... [Read more]

Starting the engine on a 2002 - MTD Yardman Garden Tractor?

MTD Yardman Garden Tractor - The engine will not turn over. Battery is fully charged. There is power to one ... [Read more]

How do I wire (basic) a 46209x9B so the engine will stop?

I have a 46209x9B that most of the wiring was gone on. I added a 3 pole ignition switch and a solenoid. I sta... [Read more]

Honda engine = Tecumseh engine?

Hello, I have a chipper/shredder with a Tecumseh HS50-67347H motor on it. That motor no longer works. I was wo... [Read more]

how do i get craftsman LT4000 lawn tractor to start?

When I turn ignition key engine clicks continuously but won't start. Is it the starter motor & if so how do I ... [Read more]

How to fix a Briggs 475 engine that starts when primed but then quits?

My Briggs and Stratton 475 pushmower engine starts up when primed, but then immediately quits, like it isn't g... [Read more]

Briggs and Stratton 28B702 1154E1?

My grandfather gave me his Snapper riding mower. Engine is a 9 hp B&S 28B702-1154E1 The pull start cord is al... [Read more]

Doesn't start the engine?

My Eager 1 Craftsman 6.25 HP is working fine. However, while I was using it, the blade hit a hard metal on the... [Read more]

transmission sears 917.2555581?

i lost my neutral wont go out of gear. lever will go in neutral but wont move. will only move with motor runn... [Read more]

How do I adjust the throttle on my Briggs 28N707 motor? ?

How do I adjust the throttle on my Briggs 28N707 motor? It runs a Yard Man 42 in mower. I can move the throt... [Read more]

Blade Belt Replacement on Snapper Rear Engind Riding mower?

I have a Snapper model 28086 rear engine riding mower. I need to replace the belt. How do you get the belt off... [Read more]

My Briggs and Stratton motor is running rich, how do I adjust the mixture?

When the mower is running, the engine sounds like it's hunting, reving and dropping. The choke doesn't seem to... [Read more]

rebuilding a lawnmower engine?

i have torn down my mower motor(yardman 6.5) now i'm ready to put it back together this is my 1st time doing t... [Read more]

replacing the pull cord on an Eager-1 lawnmower?

I have my pull cord replacement installed and see how there are flange arms that extend to engage the motor sh... [Read more]