how can i fix my hoover hdv6 tumble dryer?

yes i had the same problem and its the pcb relay . you have to remove the top via three screws from the back and the pcb is then visible. unfortunatley the two screws holding the pcb are screwed from the front of the machine. you can dismantle the whole front or in my case unscrew them with pliers on the thread end. its awkward but saves a lot of hassle. once removed just replace the new pcb and re-screw from inside. job done!

VINNY BOY
February 2012

I used the info above and fixed my dryer yesterday. The guys at espares were fantastic and I had the circuit board within 3 days. Thanks for your help!

Tricky in Elgin
November 2009

PS Put this voucher code in the promotion box on checkout and you'll get an extra 10% off the cost

XMAS2007

Mark in Dorset
December 2007

Hi, I've found the fault on the internet on a few sites and the fault is the Relay PCB. A new one can be bought from http://www.espares.co.uk/part/tumble-dryers/hoover/hdv6uk/p/1088/107/0/677491/209751/relay%2fpcb.html?k=relay
for £11.99, but it looks as though you have to take half the machine to bits to fit it. Oh not bad for £11.99 - Good luck, just off to order mine now.

Mark in Dorset
December 2007

I have the same fault on mine too, i'm just searching the internet for the answer. However to get the dryer to work i have put a link across the on/off switch and this then allows the dryer to work. BUT do not leave it like this once the dryer has stopped as it hums, open the door and it stops.

Mark in dorset
December 2007