ROVER 416 YEAR 1995 TO 1999?

how do i replace slave cylinder on rover416

robert
November 2010

my water pump drop water and the engine is overheating i need to change the water pump how do i do it my self

ade
May 2010

Thank you ANT, your advice was very valuable. I used NiCrom wire of 3 and 2 ohm (0.5mm dia). It can be taken out from heating element of spoiled electro oven. The only problem is necessity to use ZnCl (or special fluss) when soldering NiCrom wire.

Rimas
August 2009

i have a rover 416 sli 1.6 16v saloon v reg (1999) i think. the last six numbers of the vin are 466197 the engine is over heating. i have had a split in the hose at which a tempary repair is thier some where i can identify the part number on the net

michael barrington
January 2009

yes, body-colour blue

Bayar
September 2008

A COMMON PROBLEM , I BELIEVE IF YOU DROP THE GLOVEBOX - BEHIND IT IS AN ELECTRICAL CONNECTOR PLUG DISCONNECT THIS PLUG AND YOU ARE LEFT WITH A SOCKET HELD DOWN BY A PLATE WITH 4 SCREWS. UNDO THESE SCREWS AND RETRIEVE THE PLATE. ON THE REVERSE SIDE ARE THREE SPRING LIKE RESISTORS IN SERIES ONE OF WHICH WILL BE BROKEN. IT IS A VERY POOR DESIGN AND FRAGILE. YOU NOW HAVE THREE CHOICES
1-REPAIR THE BROKEN RESISTOR WITH SOLDER (IT WILL PROBABLY LET YOU DOWN AGAIN IN THE NEAR FUTURE)
2-REPLACE THE RESISTOR ASSEMBLY WITH NEW/SECOND HAND. (YOUR LOCAL SCRAP YARD MAY HAVE SOME BUT USUALLY THEY HAVE ALREADY BEEN TAKEN)
3-MODIFY THE RESISTOR WITH NEW RESISTORS FROM AN ELECTRONICS STORE. I HAVE HEARD OF THREE 1 OHM 10 WATT WIRE WOUND RESISTORS (MAPLINS) SOLDERED ON IN SERIES AS AN EFFECTIVE MOD. MAKE SURE YOU CLEAN ALL THE OLD RESISTORS AND SOLDER OFF FIRST TO GET A GOOD CONNECTION
HOPE THIS HELPS

ANT
February 2008

air fan only works on 3 and 4, but not 1and 2. how do you find and replace resistor

ed
January 2008