I have an Accenta G3 panel c/w remote keypad. Every few days the panel is going into alarm mode and when resetting it is showing a tamper fault. Both the tamper circuits on the keypad and detectors have been disconnected and it has happened again. The keypad is allowing me to reset the system and return to day mode, any ideas what is causing the problem? Any assistance would be greatly appreciated
Hi there,
It is likely to be the tamper in the bell box, as this also has a seperate circuit. Make sure when the lid is fitted, there is plenty of push on the switch.
Regards
Tony
November 2007
You need to complete a walk test along with a complete system check to find out where the tamper is then you can resolve. If you need an installation manual you can get a PDF doc here showing instalation and programming.
http://www.norbain.co.uk/downloads/manuals/Accenta_G3_Optima_G3_Version_2.pdf
marko
October 2007
You need to complete a walk test along with a complete system check to find out where the tamper is then you can resolve. If you need an installation manual you can get a PDF doc here showing instalation and programming.
http://www.norbain.co.uk/downloads/manuals/Accenta_G3_Optima_G3_Version_2.pdf
marko
October 2007
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
