Recent: Will I need to replace my garden tap?

Mend > Hedge Trimmers

Mend Ryobi PLT 3043YE Start Instructions Manual

HOW TO START A RYOBI PLT 3043YE STRIMMER?

I HAVE JUST BOUGHT A RYOBI PLT 3043YE STRIMMER FOLLOWED THE INSTRUCTIONS TO THE MANUAL WORD FOR WORD BUT IT STILL WILL NOT START. IT SPLUTTERS FOR A FEW SECONDS AND THEN NOTHING,I HAVE CHECKED THE PLUG THAT SEEMS OK,DONE THE FLOODED ENGINE ROUTINE BUT STILL NOTHING SHOULD I SEND IT BACK OR DO THE ACTUALLY WORK. PLEASE CAN ANYONE HELP

Douglas Hughes
August 2007
Follow all the guys above:-

1) make petrol/oil mix is 50:1 , This means 500cc petrol to 10cc of oil (2 stroke oil! , not 4str engine oil!) , adjust as you see fit (250cc - 5cc , 1litre(1000cc) - 20cc)

2) Prime (clear rubber button on top of engine), x 5-8 times , push yellow warm (red)

3) HOLD DOWN THE INTERLOCK BUTTON WHEN STARTING !! (big yellow button 1/2 way down shaft) - I too suffered the old start for 5 seconds, then cuts out - turns out this was the key to starting

4) Idle for while (20 seconds?) then warm up with throttle (squeeze handle on bottom of shaft)

Chris Peacock
June 2013
Remove all the old petrol (I just turn it upside down into a big mayo glass jar). Put fresh premium petrol (without ethanol) AND MAKE SURE YOU ONLY PUT SMALL AMOUNT OF OIL. My previous experience is hard starting is caused by too much oil mixture.

Jose
February 2011
I love this strimmer. Boy does it do a lot of work. However, I also think the instructions are wrong regarding starting it. Try starting it by experimenting rather than following the book!

Robert
July 2009
I have two of these. One starts perfectly every time, the other is very hard to start.

Once running both are great.

Walts
May 2009
I've sent mine back TWICE (first time the starting cord had snapped off through me trying to start it so much...) with this problem and both times it has been sent back with 'No fault'...

For the first time ever it managed to start today! For about 5 seconds... Now I'm back to 'PULL - rattle-rattle-rattle... PULL - rattle-rattle-rattle... PULL...'

Driving me totally insane!!!

DO NOT BUY ONE OF THESE.

Don't buy
June 2008
I had the same problem. Do exactly the opposite to the instructions. Start it in the WARM position while holding down the top yellow button.

Norman Smith
August 2007
May seem daft but have you checked that fuel mixture hasn't too much oil as most should be 50-1, I have used an old mustard jar or Yakult container, 1 oil to 50parts petrol.
When it splutters, too much oil will belch out bluey white smoke. Best of luck m8

andre
August 2007

Related Questions ...

Mend setting alarm optima
2

to default panel to factory setting on my alarm?

Hi,i have tried the above as instructed in the accenta optima engineers manual. this has not worked.i may ha... [Read more]
Mend washing machine delay start programme
1

Delay Start Button on HJA 8703?

I cannot turn off the delay start on my machine. I have followed the manual instructions but everytime I try a... [Read more]
Mend boiler heating burner
1

what could be the problem!!?

I have been servicing a vokera maxin 28e boiler,all the work is complete and all the pressures are correct to ... [Read more]
Mend peugeot 406 speedo
1

Peugeot 406 1.9TD 1996 speedo flickering?

Ok so when driving along, my speedo sometimes is fine, sometimes doesnt move or will jump up stick at a random... [Read more]
Mend petrol hedge trimmer
5

JCB PHT24 Petrol Hedge trimmer?

Where can I find a workshop manual for this model.I think I need to change the clutch, but would prefer some i... [Read more]
Mend navigation satellite navigation sat nav
3

how to get a manual for foehn & hirsch n30?

im lost with this sat nav it comes with a quick start up.iv no idea how to play it through speakers any one ... [Read more]
Mend How to mend it?
1

Instructions?

I have just been left a McCulloch Trimmac 240 strimmer, unfortunately without the instructions. I can start it... [Read more]
Mend help problem hello wondering
10

HELP SELF-INFLICTED PROBLEM 1.9 vivaro?

Hello everyone. I am wondering if any one can shed some light on a self-inflicted problem. I am currentl... [Read more]
Mend DVD Recorder Sony
1

Is it possible to restore my Sony DVD recorder to proper operation ?

Whilst making a recording on my Sony DVD Recorder (RDR-HXD 860) and watching another programme the notice HARD... [Read more]
Mend How to mend it?
7

15.538GS John Deere - Not a Peep Out of It?

I have emerged from a long Buffalo, NY winter and went to start my mower. Not a single peep out of it. I got... [Read more]
Mend start grass despite
2

How do I start a PWR21CCGTA trimmer?

About a year ago I think I was able to download a users manual for the above grass trimmer but despite searchi... [Read more]
Mend strimmer start air
1

Wont start?Jcb Strimmer m25?

Old chaps strimmer wont start, seems to have some sort of air filter missing, when it did start, cut-out after... [Read more]
Mend book required instruction
2

Cookworks b0906 bradmaker instructions & recipie book required?

Can anyone provide me with the instruction and recipie manual that comes with the B0906 cookworks breadmaker p... [Read more]
Mend suffolk punch lawn
2

How do I start my suffolk punch lawn mower?

Could you please tell me how to start up my suffolk punch 30s petrol lawnmower? We have purchased it with no ... [Read more]
Mend scantronic reset moved
26

Scantronic 9651 - reset user codes without user 1 code?

I have recently moved to a new house that has a scantronic 9651 system and 9930 control pad. The previous own... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Hedge Trimmers ...