Mend Durabrand PSTB-1 DTT Receivers

Find out how to mend it for free.

Ask Question

Free repair help for Durabrand PSTB-1 dtt receivers

Mend dtt receivers ...

Mend DTT Receivers

Mend > DTT Receivers

Durabrand (PACIFIC) PSTB-1?

I have a Pacific Freeview box now made by Durabrand and it is on constant Standby, left the box on over night when I came down in the morning it was on STANDBY and now it will not come out of Standby Mode when power is left off and put back on.

Can anyone tell me the exact component which has failed so I can replace it, I know they are cheap boxes but I wish to replace this for an electronic project I am doing.

Steve
April 2007

Durabrand Durabrand PSTB-1 Video, DTT Receivers

How do i reset the freeview box when i can't remeber the menu code

Darren Lambert
February 2008

ONE OF THE MAIN COMPONENTS IVE FOUND TO GO ON THESE BOXES AND CAUSE STANDBY POWER FAULTS IS IC601 LOCATED JUST BEHIND THE POWER LEAD CONNECTOR ON THE R/HAND SIDE OF THE PCB. I HOPE THIS IS OF SOME HELP

TERRY.M
November 2007

I have the exact same problem - does anyone know of a manual reboot? for this device?

Tom
October 2007

Thanks t for your answer, I am studying electronics so one day I might be able to locate the fault and perhaps fix it.

You would have thought in this day and age you would be able to fix it and not throw it away (Environmental friendly).

Steve
April 2007

No one can tell you the exact component to replace because they are not there to do the trouble shooting - I'm afraid that is you.

To trouble shoot a STB (or any electronics) you need a knowledge of electronics, know how a STB works generically, and have a circuit diagram. It is unlikely that yo will be able to get a circuit for the box because they are bought in by WallMart/Asda and, being budget boxes, are not designed to be repaired but replaced as a unit.

t
April 2007