Hotpoint Ultima WF860?

machine was working fine until last week,then it will turn on run a test(as in pic) no error codes come up
but when you start programme it goes into test mode again!!!

sue
June 2012

My machine switches off mid cycle then comies back on

David
May 2012

why does it have this silly feature on it anyway its rediculous the amount of times ive had to do this is unbelivable

mandie
March 2011

i have the same problem.. the machine always on the test mode and keeps on spinning. i follow the same procedures and it works.. thank you..

i press and hold the start/cancel button then the system restarts and the screen displayed "on". then i press the on/off and the start/cancel button at the same time. the screen displayed "D:off" this means the test mode had turned off already.

thank you.. tumbs up for you guys..

ken
January 2011

h2o keeps coming up what does it mean

looby
November 2010

it does work. machine is not doing test anymore. Why hot point doesn't include this on manual?

cecilia
May 2010

Machine leaks at start of washing cycle , seems to be from the dispenser draw , have cleaned it out and seems to be no obvious blockage , rest of cycle runs ok ?

Steve H
April 2010

press the on off button and the start cancel button at the same time this should work

Jeannette
March 2010

Thank you! it worked, thought I was gonna have to get an engineer out!

Tracie
April 2009

Just had same with mine, turn machine off then back on, when on appears on the screen then press and hold start/cancel and on/off until doff appears on screen. machine will then work

woolley
July 2008

We have just had the same problem with test appearing and have followed the instructions above by holding down the start/cancel and the on/off buttons at the same time. It works!!!! Washing machine back to normal

Julia
July 2008

I have followed your instructions on the "Stop the TEST" by holding down the START CANCEL Button. The Test did not work! any more ideas?

pavla
July 2007

Hello, we have message on our washing mashine Wf F -05. What can we do???Thanks

pavla
July 2007

Well, for an WF865 you could try this:

Stop the TEST by holding down the START CANCEL Button. Test should disappear off the display)
Then hold down START CANCEL & ON OFF Buttons at the same time for a few seconds. The message D:Off should appear in the display. That might work it.

Andy.
www.hotpoint-wf840.utvinternet.com/

Andy
September 2005

sounds like you might have to book a service engineer .
contact hotpoint at www.hotpoint.co.uk

john from stoke
January 2005