Recent: Will I need to replace my garden tap?

Mend > Home Heating Systems

Mend Worcester Bosch Junior 28i Boiler PCB

worcester bosch boiler junior 28i?

Engineer has replaced PCB, thermistors, stepper motor and boiler still fails - reset light and mains power indicator light both flash + pump switches on when there is no call for heat. Problem does not occur when eco button is activated. Engineer is stuck - says there's nothing more he can do and new boiler is only answer. Surely not?

Tom H4BC
July 2016
There are quite a few models of the Junior 28i spanning a good number of years. So assuming you haven't paid for any parts as your engineer hasn't repaired your boiler you can pay a fixed fee to Worcester & they will replace a number of parts depending on the fee you pay, there are 2 or 3 pay scales I think, definitely cheaper than a new boiler & if it can't be fixed, i.e. it's obsolete they'll tell you. Plus within the price you pay you'll practically get a refit. However, if you get your "engineer" to call Worcester tech & explain what's happening they will advise him, providing he's gas safe registered & competent then he should understand. But it sounds like he's been dibbing in the bran tub to me.

An Engineer
August 2016
"Problem does not occur when eco button is activated"

So how does the Eco button change the way the boiler works?

From the manual:

3.1.5 DOMESTIC HOT WATER PRE-HEAT
The hot water heat exchanger is kept “pre-heated” to reduce the time taken to deliver hot water at the tap. Pre-heat is enabled by default, during the initial boiler start up and the ECO button is not illuminated.
Eco mode is an energy saving function allowing hot water to be heated only as and when required, by running a hot tap, this is OFF by default.

So, in Eco mode the boiler won't try to pre-heat. (which suggests it won't run the pump unless there is demand.

Further on in the manual:

3.1.6 BOILER RESET
In the event of a fault, the reset button will flash once per second and the blue mains indicator light will flash.
1. To reset the boiler press the reset button for approximately five seconds.
When the boiler resets the reset button will no longer be illuminated.
2. The mains indicator will no longer be flashing.

If the fault remains and cannot be cleared by pressing the reset button, contact Worcester, Bosch Group for
assistance.

Worcester Bosch have a helpline 0330 123 3366

These MAY help more:

https://www.youtube.com/watch?v=_wpgiBzASvI

http://www.mrboilerrepairs.co.uk/fault-codes/worcester-bosch-boiler-fault-codes/fault-codes-worcester-greenstar-24i-28i/

XXX
July 2016
So the service engineer has been guessing and he's probably correct when he says that there's nothing more that HE can do - his diagnostic skills are not good enough and sadly you pay for his lack of skill in time and materials.

Worcester Bosch have a helpline 0330 123 3366

Good Luck...
July 2016

Related Questions ...

Mend combi boiler heating worcester bosch
2

Worcester Greenstar combi Heating works, but doesn't (??!)?

I have a Worcester Bosch Greenstar 30Si combi boiler with a Drayton SCR and RF3 digistat controls. The heating... [Read more]
Mend central heating Worcester Bosch heat exchanger
1

Worcester Bosch Highflow 400 BF boiler problem?

Hi, my boiler produces hot water on demand OK but refuses to turn off the central heating. Even with both heat... [Read more]
Mend boards combi boiler
1

pcb boards?

Hi, I have A Worcs 350 Combi Boiler in which one of the PCB boards stopped working. Does anyone know whe... [Read more]
Mend boiler pcb lockout
1

worcester 28i?

boiler keeps locking out have installed a new pcb but same problem pump ok fan ok have gas at boiler no spark ... [Read more]
Mend boiler overheating PCB
2

Worcester Bosh 30cdi boiler problems?

Boiler (3years old) will run normally until end of it,s cycle or if temp is reached. It will then over heat. W... [Read more]
Mend Worcester Bosch Boiler PCB Fault
2

Worcester Bosch Highflow 400 rsf boiler problem?

I have a problem with my Worcester Bosch Highflow 400 rsf boiler. If hot water is on, I cannot get central hea... [Read more]
Mend boiler heating repair
2

Worcester bosch 24i not going ON automatically?

Hello, I want to share how i fixed my boiler - worcester 24i. Issue: the boiler would not go on when... [Read more]
Mend boiler fault engineer
3

Worcester Greenstar Junior 24i intermittently firing up and turning off?

I have a 2.5 year old Worcester Bosch Greenstar Junior 24i boiler. When I turn on the hot water or central hea... [Read more]
Mend combi boiler PCB fault
1

Lost of hot water Bosch Worcester?

I have an intermittent fault on a Bosch Worcester combi. The hot water stops working and a red light flashes. ... [Read more]
Mend central heating boiler ignition
6

Central heating boiler ignition lockout?

I have an ongoing problem with my boiler, a Worcester Bosch 28Cdi. From time to time the central heating ligh... [Read more]
Mend boiler bosch pcb
2

Worcester Bosch 24i junior Combination boiler 4 years old?

Having had to buy a new board PCB in July 2008. Which I was not very happy about then as it was just out of w... [Read more]
Mend boiler heating pcb
1

How can I fix my Boiler?

The warning light on my Worcester Bosch boiler has been coming on and off for the past year , I have put up wi... [Read more]
Mend boiler heating condensate
7

How can I fix my worcester bosch 28i?

Hi My worcester bosch 28i combi boiler packed up(4 yrs old) so I took a look and found fuse 1 had blown. Afte... [Read more]
Mend firing hot turned
1

Combi stops firing for hot water when cold tap turned on?

Hi I have a Worcester Bosch Thermotechnik combi - on the boiler casing is a Bosch-stamped cert saying it is... [Read more]
Mend boiler PCB Worcester Bosch
1

worscester bosch 28si mk2?

Nothing happens when boiler is turned on red light just flashes on the front, fitted a new pcb still got the s... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Home Heating Systems ...