Indesit evolution 1200 we 12s Error Codes?

I just rang Indeist and they suggested checking the outlet pipe is not blocked and draining the machine by returning it to floor level. Then remove the lower, front panel to access the filter (lower right). Put down some old towels and slowly unscrew the filter. Once all the water has stopped then remove the filter fully and clean. Put everything back in its place. Resetting the machine should then resolve the problem.

Peter Steward
December 2007

Many Thanks, just need to see what codes come up now, My other half has been asked to remember them :)

Richard C
December 2006

hi richard here you go but dont take these as read these machines often throw up faults when the main board has had it

F01 Short Circuit-Motor Triac
F02 Motor jammed or tachogenerator detached
F03 Temp probe o/c or s/c
F04 Pressure switch jammed on reset
F05 Pressure switch jammed on trip
F06 Programme selector management error
F07 Heater relay stuck
F08 Heater relay cannott be activated
F09 Incompatable eeprom
F10 Pressure switch not sensing correctly
F11 Pump cannot be be activated.
F12 LCD Display module and main module not communicating correctly.
these f nos also relate to the no of flashes

phil grimshaw
December 2006