how to change rear hub oil seal ldv convoy?

were is the rear axle oil breather many thanks.

jeff
October 2015

need to change the rear hub seal on my ldv convoy but not sure of the size of sock i need to remove nut.

martin
March 2015

dont forget to clean out the axle breather!

k
April 2014

many thanks all of just got to put back together when I get seal thanks again

hippy dave
April 2014

Remove drum and ring of bolts holding half shaft in,knock back the locking tab on the large nut,sorry can't remember the size and remove the nut,remove the tab and should be another nut under there,if at all possible take note the position and tightness of this nut and try and replace back to it's original position, if not you will need the adjusting data,draw off the hub assy,place in vice and lever out the outer dust cover,under there is the oil seal,lever out also,usually knocked in the new seal with a hammer and block of wood,refit dust cover and rebuild in reverse making sure the locking tab is correctly fitted,you may get a gasket for the half shaft in the kit also,good luck

cdc
April 2014