Scantronic 9600 keypad blank/dead?

open keypad check to see if you have power to it,if you dont then fault in end station,its a very old but good panel,if you have engineering book then you could try to reset it back to factory conditions,this somtimes can rectify fault check battery first,make sure you check cable to keypad for damage,

gts
January 2012

No it has not been serviced, I changed the battery a couple of years ago. Is the thinking that I should change the battery again and it should work? (Assumed it would still be powered by the mains power?). Also without a working keypad I cannot get the alarm into engineering mode, which is what I did last time I changed it) thanks.

Steve
January 2012

Had it serviced?
Duff battery can cause that.

Alarm
January 2012