Beko WM5120W wont start!!?

Thank You Ill give that a try my fella has a multimeter I think so ill get him to bring it round...Ill get back to you and let you know if it solves things.

Kat Parker-Barnes
November 2011

if the wm persists with the problem and the heating element has not failed,inspect the carbon motor brushes ,.remove the motor,take out the brushes and inspect for wear,should be no shorter than 10mm .

mech monster
November 2011

sounds like the heating element ,or a problem with the heating circuit .this would explain the machine tripping mid cycle.and the machine aborting.this is a way of ruling out the element.locate element located at the bottom of the outer drum ,the element will have two wires and a 10mm nut that secures the element to the casing .once you have identified the element ,remove the two wires and tape the wires together .make sure you use plenty of insulation tape and secure the wiring so it cannot foul or hinder moving parts. now test machine .if the machine now cycles and doesn't abort.replace the element.do not use the wm for any length of tlme ,this is mearly a test procedure.the safest way to test the element is with a multimeter if you have one .get back to us and let us know how you get on .remember safety first always unplug the appliance prior to inspection .

mech monster
November 2011