what does fault code mean candy go482?

Hi there I have a candy go482 it will not drain. I have put a new pump in there and checked all pipes for blocks. They are all ok. I have ran the following test on it
Only run the test program with an empty tub. Turn the program selector to off. Press & hold in the first option button on the left (usually spin speed). Turn the program selector 2 positions clockwise. Release the button as soon as the LED on it illuminates. Once the button is released all the option LED’s, maximum spin LED, + all LED’s on the residual time indicator should become permanently lit. Within 5 seconds press the start button. If successful the residual time LED’s and the max spin LED start flashing alternatively with the option LED’s & the test program should start automatically. The machine then goes through a sequence of testing each function in turn. If a fault occurs the program is stopped and an error code displayed. Error codes are manifested by a repeated series of flashes on the first option LED & first LED in the residual time indicator (more or less straight above the option LED). Should an error be found you should see ”x” flashes – pause – then repeat (until the machine is switched off). To exit the test program at any time turn the machine off at the program selector. Good luck...post results.

And the far left 90 min and stain vanish less flash 3 times then go off then do it again
Would you know what this means many thanks

ronnie
August 2011