Hotpoint wma 32 door lock flashing?

I had the same fault, it turned out to be poor solder connection on a surface mounted resistor on the control pcb.
Use a magnifying glass and check all connections for poor/cracked soldering

watteau
November 2011

If it is not the door lock or the pcb module has been burnt out the it is the motor

whitego
March 2011

I HAVE THE SAME PROBLEM EVEN AFTER REPLACING THE SPRING WHAT NOW ANY HELP??

WASIM
October 2008

Thanks Barn ive tried this but it seems ok any further ideas.
Phil

philip
September 2006

Have you checked the door lock catch on the door the spring may have snapped if it has its an easy repair just unscrew the door off the front of the washer then take out the six screws holding the door together split them replace the spring re-clip it together and re-assemable

Barn
September 2006