Recent: Will I need to replace my garden tap?

Mend > Switches and Sockets

Mend Triton Replacement Electrical Switch

Can I leave the pull cord switch on shower on all the time?

I have had to replace the pull cord switch on triton shower twice this year. Should I leave it on all the time or will it burn out.

yvonne
October 2010
I have a shower wall fitted Isolation switch I am now on my 3rd switch having burnt the last two ut one lasted approx. 7 years last one 8 months then had the smell of burning when using the shower after I came out , I NORMALLY TURN THE SWITCH OFF ND ON WHEN USING THE SHOWER /can I leave this switched on permanently instead of keep turning it on and off and did the switching on and off cause the wires to burn ?

ronnie m
December 2019
never leave it on i am an electrician i have seen the damage it can do if left on all the time it has melted peoples cables and can cause fire

i understand from pulling it can cause it to break but look for the ones made by mk alot more robust

kevin
April 2011
i have never turned mine off. never had a problem its there mainly for maintainance

mark juggins
October 2010
dont like to contradict cantona,but he is right on one thing,replace the switch,its ment to be used as an isolating switch,not to turn shower on and off,use the shower controls to do this.so the answer to your question,you can leave it on all the time,its safe to do so

gts
October 2010
don't leave it on waste of money and energy if its snapping like this it could be a stiff switch inside resulting in you pulling it alot harder than you really shud.
replace switch or have a wall mounted switch installed.

cantona
October 2010

Related Questions ...

Mend switch working button
2

Beko DWD 5410 W on/off switch not working?

The button is not staying clicked in, thus no power to the machine. Do I just need a replacement button at £... [Read more]
Mend cylinder valve pump
1

replacement for Danfoss thermostatic cylinder valve with pump switch?

I have been advised to replace the old Danfoss thermostatic cylinder valve but my old one has an electrical sw... [Read more]
Mend ideas bought help
2

Need a new switch ?

Need a new switch for FMTC 1500 TK table saw. Any ideas where one can be obtained please? Bought it from B&Q... [Read more]
Mend replacement replace action
1

punto wiper switch replacement?

Does anyone know how to replace the wiper switch assembly on a Mk2 Punto. The intermittent wipe action is very... [Read more]
Mend Potterton Thermostat Hot Water
1

Fauly Potterton EP200 Programmer?

Even though my programmer is at OFF and the room thermostat is LOW, my heating circuit is on at the same time ... [Read more]
Mend dryer fault starts
2

Zanussi TCE7227 Condensing Tumble Dryer - Intermittent fault?

The dryer starts but suddenly stops again. I have replaced the motor capacitor on a previous occasion and this... [Read more]
Mend boiler pcb pressure
19

40 60 80 error on Chaffoteaux boiler MX2 24FF?

I have the above boiler displaying a 40 60 80 error message on the front panel. From the instruction/user manu... [Read more]
Mend hp engine craftsman
3

Stopping a 8 HP Briggs & Stratton Snowblower engine?

I inherited a Craftsman snowblower that needed some work. I have replaced parts and have it running; but must... [Read more]
Mend recliner power recliner la-z-boy
6

I need to fix my La-Z-Boy Luxury Lift recliner?

My La-Z-Boy 1LH Luxury Lift power electric recliner is stuck in the reclined position. When the Up/Down switc... [Read more]
Mend dyson vacuum cleaner motor
1

Dyson DC07 motor - Where can i get a new thermal cut-out switch?

The motor fitted to the Dyson DC07 and some other models is the YV 2200. Attached to the side of the motor is ... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Switches and Sockets ...