Beko DWD5410W doesnt heat the water ?

Even more from mach2027......

My suggestion that using a 12V relay instead of a 9V is actually not guaranteed to always work.
I currently recommend the readily available:

OMRON ELECTRONIC COMPONENTS, G5LE-14 DC9, RELAY, SPDT, SEALED, 10A, 9VDC

mach2027
September 2013

More from Mach2027,
The relay I purchased from Maplins failed after a few days use. I then fitted a new heater, assuming it was drawing too much current. The relay failed again after several days use. I then fitted a 16 AMP/240V relay (Omron G5LE-1E 12DC) & now all OK. The heater should only draw 7.5 Amps, so my conclusion is that the Maplins relay, although rated at 10 AMP/240V was not up to the job.

mach2027
October 2012

Hi,
The heater relay had clearly overheated on my control PCB. This resulted in the Dishwasher not heating or sometimes getting hot, even when the unit wasn't running a program (shorting).
The relay was easily replaced with a 12V relay (not 9V) from my local Maplins store. Part Number JM67X - Cost £1.30

Mach2027
September 2012

replace the ntc

James
January 2012

Many thanks, I too wasted £30 on a new element, just wish i had read this first!

Mantis
January 2011

I read this thread about a week ago,went on the advice of taking the pcb out and low and behold there was indeed not one but two scorch marks on it so i re-soldered and it now works perfectly.
Thank's for the pointers.

Dave
September 2010

Hi Pez, is it safe to resolder the joint? I have read that it could burn out

Wes
August 2010

Hi WES
If you have not already changed the relay, try just resoldering the joint. This has happened to me before, and I rushed out and bought a water heater (which is now a spare), when all I had to do was resolder, I have done this twice now and both times it has worked! It takes no more than 20 minuites start to finish. Hope this helps.

pez
August 2010

Hi, I have found out what the problem is, in case anyone happens to read this, its not an issue with the water heater its a problem with the control pcb. The part that has gone costs around £1 but I can only find it at CPC "SCHRACK COMPONENTS - T7NS5D4-12 - RELAY PCB SPCO 12VDC" so it will be more like £10 with delivery. Anyhow if you have a similar issue check the board first, its clear where the problem component is as the pcb will be burnt around the solder joint.
Wish i had checked this before I purchased a new water heater ! It looks easy enough to fix but if your not confident the board is about £40 here...
http://shop.ukwhitegoods.co.uk/Dishwasher+Parts/Beko/Beko+Timers+%252526+PCBs/1899410404+Beko+Dishwasher+Control+PCB.html

Wes
August 2010