Mend > Dishwashers

Mend Indesit D4000 - IN/DW 9 Dishwasher Cycle

How can I fix my Indesit D4000 - IN/DW 9 Dishwasher?

My dishwasher works for a short while on any cycle but then blows the main CB in the distribution box. Is this a known problem? If so what component should I be changing? And do you know where I can get one?

I suspect something is either getting wet, or hot, causing temporary failure. There is a large capacitor unit attached to the mains input. Could this be causing it?

Steve
November 2004

Indesit Indesit D4000 - IN/DW 9 Kitchen Appliances, Dishwashers Indesit Dishwasher Cycle

I have an old dishwasher Indesit D4000 and the heater element has gone. How much would it be to replace and fit this? Or should I get rid.

Gaila
March 2011

Can you tell me the programmes on this dishwsher Indesit D4000?I dont have the instructions. I think it has 4 main settings - which setting is for what wash?

Chris
October 2008

CAN YOU PLZ HELP WITH MY DISHWASHER INDESIT DI 67. IT CAN BE TURNED ON, BUT THATS IT, THE LIGHTS FLASH,IT BLEEPS TO START BUT DOESNTAND THE PROBLEM TROUBLE SHOOTING QUESTIONS ARE RUBBISH.DO YOU THINK ITS THE TIMER,BUT ITS ONLY 16MONTHS OLD,IVE CHECKED THE WATER FLOW THATS FINE CLEANED ALL PIPES FOR ANY BLOCKAGE THERE FINE.

DIANE VEGH
January 2005

Mine did this so I replaced the heater but still no joy- resistance was the same as yours on both the new and old heaters. I have now found that it is the wash cycle that does not run all the time - leading to the heater getting very hot - I presume it is either this or the motor that is tripping the circuit breaker.

Drossel
December 2004

Steve, not sure but i have the same problem when it goes thru cycle 4 to 5. Anyway disconnecting the heater allows the program to finish (without heat obviously) Heater resistance is 25 Ohms, but checking resistance between element and heater connection gets high resistance in places. This probably causing leakage current and tripping RCD.

Going to try another heater.

Ade
December 2004