Recent: Home max fs506x?

Mend > Switches and Sockets

Mend Multimetrix DMM105 Test Air Pressure

How do i use a multimeter to test for voltage and continuity from a pcb,?

I need to test the air pressure swich on my boiler,i havn't a clue how to use a multimeter, ie settings / voltage....can you help it is urgent as my kids need a bath and i can't afford a heating engineer...
Thankyou

The multimeter i have got is a multimetrix DMM105

smiddy
April 2006
Put it on the ohms or diode test setting

Juan Skinner
October 2006
Sorry to take so long but I thought that some one would answer this. Sorry again to be blunt but if you don't know how to use a multimeter you should not be monkeying with a heater - it is dangerous.

Terry
June 2006

Automatic Answer

We may have found other answers which could help you.

Click here for Test Air Pressure

Related Questions ...

Mend How to mend it?
1

How to remove engine checklight?

2004 Honda Civic  Regular transmission  ES5  Singapore Car PROBLEM: The engin... [Read more]
Mend How to mend it?
1

megane 2005 aircon?

hi i have a megane 1.5 dci air con dont work had it regased told it was regased but still dont work ive done... [Read more]
Mend water working properly
2

water ?

Carver Crystal Water flow not working properly. Connection: Operated by Whale pressure switch in the cold IN... [Read more]
Mend potterton pressure switch profile
3

Potterton Netaheat 80e - diagnosing air pressure switch problems?

Hi, I have a Potterton Profile Netaheat 80e boiler. I had some problems with it last year and through these... [Read more]
Mend brakes iveco horsebox
4

Iveco Brake Issues?

Hi, I have an Iveco Cargo which is used as a horsebox. I've recently had a brake caliper replaced to get it... [Read more]
Mend ignition pcb red light
1

Potterton Suprima 50 - Pilot won't light?

Lovely flashing red light after three or so attempts by the boiler to re-light the pilot. Reset just restarts ... [Read more]
Mend boiler heating fault
2

How can I stop my Ravenheat CSI 85B tripping out?

I had a new Ravenheat CSI 85 B T installed today. It worked for the plumbers who installed it - they left and ... [Read more]
Mend ferroli f37 fault
1

why does my ferroli domicompact f30 only work in test mode?

In normal mode I keep getting F37 fault message ( low system pressure) although bar pressure is showing 2 bars... [Read more]
Mend boiler pressure faults
4

Expansion Vessel Help needed ! ?

How do you test an Expansion Vessel for faults - should there be air in there when you press the bleed nipple ... [Read more]
Mend carburetor fuel leak
5

Zama Carb leak, bulb not "filling" elastomers, cleaning, etc Husqvarna 125L?

First I will get to the immediate need and then the general questions. I know that your business is oriented ... [Read more]
Mend iveco air pressure warning light
1

IVECO 75 E15 LOCATION AIR PRESSURE SWITCH ?

V REG IVECO 75 E15 ,ON INSPECTION (PRE-MOT) WHEN PERFORMING AIR DROP DOWN TEST,TO CHECK LOW WARNING BUZZER/L... [Read more]
Mend ford cargo 1985
9

Ford Cargo 1985 6200cc?

Try and keep this short! Last year begun having probs starting, esp in cold weather. Red 'charging' light on q... [Read more]
Mend air pressure brake compressor
5

I have low air pressure on a 7.5 ton man lorry?

I Dont know if its faulty compressor, i dont have any test gear.The symtoms are when the air tank is full if y... [Read more]
Mend Iveco Daily Diesel Fuel Pump
13

02 iveco daily need help?

i have iveco daily 02 hard to start.a sniff of easy start and it goes ok i bought the van with this problem an... [Read more]
Mend Iveco Daily Diesel Fuel Pump
3

iveco daily 02?

i have iveco daily 02 hard to start.a sniff of easy start and it goes ok i bought the van with this problem an... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Switches and Sockets ...