Please help, we have not used our shower for a few months, went to use it last night and it cuts out after a few seconds........it will only run properly on cold function if you turn it to med or hot setting it cuts out totally but if you press the off button the cold comes out ok before switching off completely - basically it works fine on cold setting anything other than that the water spurts out fast then not at all
our shower makes a banging noise when you switch it on
mr wallace
August 2017
Have to hold the on/off button in to get the water to warm up
Alan S63
May 2015
Just replaced the thermal cut out because shower wouldn't heat up. Now it won't come on on the high setting just medium and cold
paula
December 2014
temperature control not working. also water temperature occasionly goes very high
robert freeborn
August 2014
Hi am having a problem with water leaking out the top of the hose before it reaches the head. I've took it apart several times and can not work it out. Can anyone help?
Tom
February 2014
My redring expression 5005 started to leak in the black vent tube, please anybody could help me what is the problem of my shower.
replace the small rubber seel in the outlet ubend
kkoko
October 2013
Keeps coming on and of untill you switch the pull cord of
John bettley
September 2013
Hi water is coming out of the pipe at the bottom of my shower and out of the hose as well
margaret
March 2013
My redring expression 5005 started to leak in the black vent tube, please anybody could help me what is the problem of my shower.
Roland
August 2012
won't come on right away pulses
Andy Mackay
April 2012
Just had ours fixed today under the guarantee. Was pulsing on and off when switching off or not switching off at all other than at the main switch. Engineer reckons it was the on/off switch which had been affected by water getting in when the shower was on. There is a new cover which fits inside the unit and protects the button.
Obviously an after thought
Alan S
October 2011
I spoke to Redring Technical & they identified the problem as the Phased Shut down PCB. Part No for 8.5KW model is 93550835 - cost £27.60
Promptly delivered by Redring & easily fitted. Four terminals to pull off & re connect.
IsaacB
September 2011
my redring shower wont turn off,what can i do
r edwards
July 2011
I have the same problem, who makes Redring (thrown out all info). Does anyone have any contact numbers
Mel
September 2010
My Redring Expressions 5005 Pulses / pumps intermittenttly severly when switched on when using either the high or low settings, i thought it might be a preesure fault but the pressure appears to be fine. Does anybody have an idea what the cause may be???
Roy
August 2010
I purchased a new PCB (circuit board) direct from Redring as is the least expensive place to get it. Redring advised that this bit was causing the trouble, and my shower is working perfectly now, was easy to fit - it just clips in.
hope this helps!
a mcb
January 2010
I just phoned Redring and they are confident that the fault is the circuit board.
The part number for my shower is 93597813 and should only cost £20 to replace this part.
They say its easily installed. Will let you know if this fixes it.
a mcb
November 2009
I have the exact same problem - dont think I sent in the warranty card though. Hope this is an inexpensive problem to fix!
a mcb
November 2009
Hi, I'am having the same problem exactly with the Redring 500S. Will be checking it out later. Are you aware of the 36 month warranty for domestic use so long as you sent in the registration card.?
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix baths and showers.