about the belt?

Hello,

Here are the instructions for removing the cabinet.

The whole cabinet is removed in one piece. Start by removing the plastic endcaps (if you have them) on your console. Once these are removed, remove the screws to the console and pull the console towards the front slightly then flipping it back. Under the console you will see the lid switch connector, unplug it. Stick a flat screwdriver into the clips and push handle toward the rear of the washer to release the clips. Once those are out stand in front of the washer grab the middle and side of the cabinet and rock it toward you and place it out of the way.

JP
February 2006

Hello,

Ok Paul, Your washer motor works on agitate and spin but the basket doesn't move? Check out the motor coupler that fits between the motor and the gearcase. It is a 3 piece part that rides on those two shafts and is not difficult to replace. Once the cabinet is removed remove the pump clips and push it out of the way and then remove the motor.

JP
February 2006

Hello,

If your model number is 110.20722990 your washer does not have a belt.

JP
February 2006