Peugeot 307 sw brake lights have failed ?

Thanks to reading these answers.. I did the switch replacement myself... .. Rather chuffed

Tanya
August 2017

you must twist anti clock to remove and clockwise to fit get someone to push brake pedal befor fitting hold down and fit then release after fitting, this also affects cruise control

tony
April 2016

the brake light switch is uder oass glive box its white and in a round plate right under

chris
November 2014

Hi I can't see any switch on my 307 Hdi 2002 ' I've pulled the carpet back under the glove box and the only thing I can see is a green plug with 2 wires that something goes into

joe
December 2013

307 on 2003 plate,similar problem centre brake light is working, brake lights are not, changed bulbs, all fuses look intact, the only thing out of the norm was reversing bulb had blown completely,

noel
June 2013

hi i'v got a peugeot 307 on a 55 plate brake lights ant working checked the fuses they are ok any surgestion plz

michelle
October 2012

Emergency braked and also lost my braking lights.!

Bashir
February 2012

Ive checkes bulbs and fuses on 51plate 307 1.4, pushed in etc, stil not working normal tail lights are working. So relay swich requires changing?

tony
January 2012

its usually the plunger that is pushed in to far on the brake switch you can pull it out as there are notches on it pull it out one inch then refit it is normaly caused by really heavy breaking that causes the plunger to go into the body of the switch , somtimes the plunger is broke or the switch has gone on the inside so you have to change it ,i got one on ebay for £18 here`s the link copy and paste it in your address bar http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=180594143032&ssPageName=STRK:MEWNX:IT -also note what type it is some are green ends and some are white replace like with like

wayne
May 2011

my brake light are stuck on and i was wondering if any one
knew how to test the switch or get them to go out.
thanks.

darren
January 2011

Don't forget when you do refit the break switch get someone to push on the break pedal then fit the switch and get the other person to release the pedal. This should reset it properly.

David
January 2011

i too have the same problem and have disconected and reconected the plug but still no lights, there seems to be a plug that isnt plugged into anywhere (just taped to another wire), if i were to buy a switch is it easy to fit or do you need to cut wires and things, thanks, Liam..

liam
December 2010

Just recently purchased a brake light switch and harness for our 55plate 307. Peugeot stated it is a common problem with these models of 55 and onwards. Total cost for parts £30, a 2 minuite fix, located under passenger footwell.

Paul Wrigley
November 2010

thanks for this, this was the problem on my one

PB
May 2010

same problem, you just saved me a fortune, thanks :)

Nige
May 2010

I had this problem and the brake light switch was out which i plugged back in. On the Peugeot 307 it is on the passanger side underneath the glove box.

Tarina
April 2010

rear break light on nsr not working brake light is working how can i fix problem

pete
March 2010

try taking trim off bottom of glovebox 3 cllips i think, then look up behind glovebox with torch. there will be brake light switch 2 wires coming from it. try pushing it in. if still not working probably switch gone. replace brake light switch. also which lights come on when driving??

me
March 2009