How can I program my remote?

The Ross website is http://www.ross-style.com.
Full instuctions and codes for all remotes are there

Nick Bridgeman
November 2009

I have the ROSS universal remote for Sky+ (TVRCSATPS-RS)so if it's a similar handset this is how to do it..


1. Turn on your TV.
2. Find your TV manufacturer listed in
the code list. e.g. Phillips is 0944.
3. Hold down [select] and the red
button together for about two
seconds, until the red LED on the
remote flashes twice.
4. Press [TV] again.
5. Key in the four digit code for your
brand of TV. The LED on the remote
control will flash twice. If the LED
illuminates only once, re-check the
code for your brand of TV and start
again at step 3.
6. Press the [Power] button on your
remote control. If your TV switches
off, press [select]. The LED on the
remote control will flash twice. If your
TV does not switch off, press [TV],
then press the [Power] button.
Repeat this (press [TV), then [Power])
until your TV turns off, then press
[Select].
HOPE THIS WORKS FOR YOU!

Ernie Wood
January 2009

1. turn on tv
2. hold TV button for 5 secs until led starts blinking
3. enter code then try, or try next code!

codes listed for Hitachi are 1050 1055 1065 1074 1116 1166 1168 1170 1178 1181 1186 1187 1188 1198 1203 1206 1207 1209 1216 1239 1251 1253 1257 1354 1355 1356 1357 1358 1359 1360 1361 1362 1364 1365 1366 1367 1371 1380 1381 1388 1393 1402 and 1407

I have had no luck finding a web site for Ross but their Technical support is on 0845 194 7584

Nigel Barnes
November 2008

if you go to the manufacturers website that made the remote contol. you can usually get there product and a link which takes you to the instructions. hope this is of some use to you.good lcuk

miss troubled
October 2008