Flavel Milano 60 gas oven?

Got the cook from Currys unable to adjust temperature on my oven

Mrs Annette Oddie
February 2021

How do I retreve metal plates for door hinge

Niel
January 2020

The metal plates beside oven burner are of. Would like to see a pic of where they should be. Please.xx

Rita Simpson
October 2017

Unable to adjust temperature on my Milano g60 owen

Baljinder Bamra
August 2016

My oven lites but as soon as i release the knob it goes out wat is it please

kirsty
March 2016

What length thermo couple do i need for flavel ilano 60 gas oven, dcgml6s

louise kornel
June 2015

Took my oven door of to clean and the metal plates that the screws screw into have dropped do i need to turn of the gas before i unscrew the oven

liz
June 2014

I am unable to light up the burner on my cooker, suggestions please.

E ijaz
April 2014

The glass lid will not full close or open?

Denise
February 2014

My light button has been pushed into the front plate. How do I take the plate off to put the button back in place?

Bill
November 2013

TRYING TO REPLACE THE OVEN DOOR ON A MILANO 60 IS A NIGHTMARE. What the hell is the bottom panel? Wished I never bought it in the first place as the pan supports slip all over the place.The oven never cooks evenly and the general summary of this cooker is that it was designed and put together by a bunch of school kids. Is this the one that has been gassing people with carbon monoxide?

Jed Batty
September 2013

I have the same problem with the grill in this oven.....could it be the door contact or ?

Kim Kyhl
March 2013

need a shut off valve

tony
December 2011

The door fix:
undo the 4 retaining screws for the oven surround and the two screws for the bottom panel. A bit of leveraging with something allows the oven surround to come out about 1 inch. Retrieve the hinge back plates from the bottom where they have fallen down. Thin long fingers are best, but push the back plate back onto the inside of the surround to line up the holes, similarly line up the hinge bracket and insert screws. the top hinge is more of a mare because you have to also have the door in place. The surround metal is quite sharp and pinches, not a nice job, you'll need help to position the door on the bottom hinge at half ajar and jostle it a little when lining up the bracket, the surround and the hinge screw holes. good luck

Lezdudeski
January 2010

if you having problem with the gas supply ,say you lite one ring then another and the flame goes out first thing to do is look at the shut of valve on the lid located left hand side at back of lid ive been called out to a lot of these problem and its all down to fat and grease sticky the shut of valve even had a few where the screws where lose and valve had droped down (DO NOT TRY TO REMOVE VALVE LEAVE IT DOWN TO A CORGI ENGINNER ) but just try cleaning the grease of see if that helps .

corgiman
October 2009

mine is the same oven will ignite but as soon as i take my hand off the knob it goes off help

gman
June 2009

i took my oven door off to clean and put it back together but on the hinges the metal plates that the screws screw into the oven have dropped so now i can't screw oven door back on help how can i get into the oven to but metal plates back in possition so i can screw door back on?

lorraine
June 2009

The thermoelectric valve or thermocouple is faulty,get a Corgi engineer in to test and replace the part.

Gasman
September 2008