iveco 35c12 tipper?

to any body reading this, its been a while and ive actually sold the iveco but after getting an autoelectrician to test it through he found nothing, somebody mentioned to me in the pub that thay had a problem with the pins in the stalks themselves, after a demolision job to get them out they were all loose, i would have thought the auto electrician should have found this, after a bit of soldering they worked fine, went through the mot, then my business couldnt afford to run the beast, so i sold it! looking to get another now as things pick up again, and will proudly go for another iveco! thanks to every1 for their help!

big g
July 2009

that didnt work changed the control unit. changed hazard switch itself checked fuses all ok think i have pretty bad problems. can somebody please reassure me! thanks

graham
October 2008

had a look im about 80% sure i found it, big plastic black unit just under the steering wheel nxt to the ignition. right under the grey plastic steering column cover. think it has 3 or 4 groups of different colour wires with 3 or 4 different connections. of which i think 1 side probably goes to the other windscreen wiper stalk. does this sound about right? or is the part a problem deeper in the dash? thanks in advance again.

graham
October 2008

control relay for indictors is in the steering column most likely losse. out of its clips to find it directly infront of you there is two little screws remove and directly below one large screw remove pull bottom gently. one control board. cost aprox £95. there is two locking clips on front move gently to release. hope thi helps.

unouno
September 2008

www.williamsdiesels.com
you are replacing the ecu, under the steering colum covers, lower section. if you get it from iveco you can see the pieced that you are replacing

Deano
September 2008