Indesit won't spin properly?

Similar root cause as for previous reply, but different scenario:
Nut on back of drum shaft is loose, allowing drum to move foreward. This allows water into bearings, causing increased wear and friction, causing overload on moter during spin cycle.
The ultimate end result is as I have described elsewhere.

David Clark
February 2006

Possible failure of drum bearings.
Sagging drum rubbing against inside of tub, causing excess load on motor during spin cycle.
To Test:
With no water or washing in the drum, push and pull the drum gently in and out, and up and down. If there is any significant motion accompanied by a slight 'clunk' the bearings have probably disintegrated and will need to be replaced.

Probable replacement parts:
Bearing set (approx £18)
Bearing Seal (Approx £7)

Possible replacement parts:
Spider/Shaft Assembly (Approx £30)
Drum drive belt (Approx £10)

Worst Case replacement parts:
Plastic Tub assembly (Don't Know - guess £100)

Some previous experience of dismantling and rebuilding washing machines required.
Previous experience of, and tools for removing and replacing bearings required.

See my other reply to "How do I fix my Indesit W113...." for more details.

David Clark
February 2006

check the carbon brushes and the motor armature

aa
May 2005