I have a fault with my alarm that even if its off sometimes it starts beeping as if thew keypad is being press and gives the error tone. This will happen for a few minuets and while its happening the keypad buttons give the error tone rather than the usual tone and then when it goes into full alarm because of the problem cannot silence so have to power it down. Its intermittend and i have swapped the key pads over and even left one disconnected. I thinks its either a PCB fault or cable fault?
Hi Jamie, now first of all these engineers are trying to help you which you should appreciate but second of all here I am seeing nothing but crap advice instead of buying texecoms cheaper crap you should of spent at least £90-100 on a texecom premier something that has intelligence most engineers I have read about seen and met seem to think scantronics are not in the same category as veritas, optima but they are due to there low prices and cheap quality ive ripped thousands out in peoples homes and replaced them with premiers and I have never been given bad feedback or had people ringing me telling me its f***** quality panels worth the price.
Nick
January 2015
Gents,
I did not make that comment so stop the abuse its obviously spam
Jamie Stone
January 2015
so,use your one brain cell,replace the pcb,and when not work,replace all the faulty cables,and when that not work,call out an expert,let him teach you a thing or two about alarms systems,i just love you arm chair experts :-)I have only been in the trade 40 odd years,what do I know ?
gts
January 2015
oh get lost, if none of you have anything helpful to say do not reply. idiots
jamie stone
January 2015
how many beeps does it give?
gts
January 2015
IMHO, best thing to do is take a hammer to it, then buy yourself a decent alarm like a scantronic 9651 or 9448.
jim
January 2015
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
