Cut cable wires spliced correctly and insulated.
The alarm was set off when the cable was cut, so I assumed the fuse/fuses were ok.
The system is not under contract, is it probable the alarm has been installed in such a fashion that it requires the installation engineer to repair/re-set?
he not say where the fuse was blown,alarm guy,could have been in the panel.,but hey ho ,its fixed :-)
gts
March 2012
Should have been a 3 AMP fuse in the FCU.
Alarm
March 2012
thank you for your reply,glad to be of service
gts
March 2012
Thank you very much, it was a 1amp fuse.
Alex Scott
March 2012
remove the fuse from the spur unit that feeds mains power to the panel,open the panel,check any fuses with a test meter,replace any blown fuse,close panel,replace the fuse in spur unit,then press reset,your panel is a budget one,so i doubt it has been programmed as engineer reset ,
gts
February 2012
So what is your question?
Never assume.
SD
February 2012
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
