Garden Tools, Chainsaws

Replacing Ryobi PCN4545 oil pump?

Hi, There are a lot of questions on here regarding the pcn4545 oil pump but none clearly explain how to get... [Read more]

Husqvarna 60?

Run sometime but run hot hard to start blow oil from sparkplug if its a lil loose

how can i fix my ryoby pcn 4545?

pcn 4545 ryoby wont start not seized. spark at plug , compression seems ok. engine suddenly died whilste in ... [Read more]

?

How can one get a battery for parkside hand held garden shearer - no one seems to stock them any more - the mo... [Read more]

how can i fix chainsaw mac 335?

cleaned out tank.....starts....then stops....seems that brake might be slipping back on each time causing cut ... [Read more]

how can I fix my Performance Power chainsaw?

It has started to use a lot of lubricating oil - refill every 10 mins. Can't tell if the O ring seal is damag... [Read more]

assembly walkthrough?

How to assemble a montgomery ward tmy 24078a. Model 600064b and serial 11-012979. The casing was off and i dis... [Read more]

How to fix drive sprocket wheel?

Replace drive sprocket wheel on Aldi Gardenline 37cc Two-stroke Petrol Chainsaw part number 25 in manual

1L291C301 0R 358 356 242?

how or where is fuel tank vent located

chain saw drive wheel?

I have a LANDXCAPE GCS350N and the drive wheel has been lost .Can anybody help me to find a new one

Poulan 245A chainsaw pullstart?

When trying to pullstart, it will lock up and almost break wrist. Seems like too much compression. Is there ... [Read more]

Ryobi 4545chainsaw worm drive?

Hi I am in the process of fitting a new oil pump and noticed that the worm drive turns freely on the crank sh... [Read more]

Piston for a Ryobi RCS3535CA chainsaw?

I have used the chainsaw a couple of times and it has now holed the piston, where would I get a piston and pis... [Read more]

Maculloch 438chainsaw safety bar in pieces stuck putting back?

I ve taken the handle off and cannot see how the looped spring goes back to operate the fail safe lever/ handl... [Read more]

coil for 90s mcculloh chainsaw?

wanted coil no.223876-01 for mcculloch chainsaw

Homelite chainsaw ?

When using my chainsaw I can't get the brake to release unless I pull the bar back and hold it back. With the ... [Read more]

have a mcculloch gas power blower ?

how can I adjust mcculloch gas power blower mos- 40005102 ser- 1... [Read more]

the starter rope is hard to pull?

my homelite 45 motor will spin over with ease with the spark plug out. it acts like it is in a bind with the p... [Read more]

tarus chainsaw 4500?

Hi i purchased a new chainsaw last year and worked fine. I tried again to use this year and will not start. If... [Read more]

Ryobi petrol chain saw RCS 40406C?

My chainsaw is not delivering chain/bar oil from the reservoir to the chain. I have cleaned the chain guide an... [Read more]