How to mend ... Getting Through Engine

where the pipes for vacuum fit under the egnition?

ignition vacuum drawing wanted . my garage has fitted a new barrel but the engine wont stop now can you help m... [Read more]

Renault clio wont start?

My son has a L reg Clio - have taken off starter motor, cleaned and when put back on starts about 5 times and ... [Read more]

How to adjust snapper mower deck belt ?

On rear engine model

Loud Whining Noise - 2001 Fiat Punto?

I don't know anything about cars but was hoping someone might be able to help...When I've been driving my car ... [Read more]

big time stuck vectra B 1997?

Hello I hope you can help i have 1997(R) vauxhall vectra sri i have the orange engine light come on so i did t... [Read more]

Running problems?

I have a mountfield with a Honda GCV135 (4.5)HP engine. It starts ok runs for about 20 seconds & cuts out. I... [Read more]

how to remove a starter motor ?

on a astra vauxhall van 1.7 td to remove a starter motor ( isuzu engine)

how do i wire starter correctly on my lawn mower?

i have a craftsman lt 1000, with a briggs & stratton intek 18 ohv. Changed the motor to a 20 hp kohler engine.... [Read more]

starter motor?

how to remove a starter motor from a vauxhall astra van 1.7 t d (isuzu engine)

Bob Villa Signature 917.274033?

My engine started smoking from the exhaust when it is put under a little bit of a load. The smoke is light co... [Read more]

Radio Station Memory?

I have a Pioneer DEH-2100UB and have sucessfully installed this in my Skoda Fabia. Everytime i turn the radio ... [Read more]

how much oil to mix with petrol for a mercury boat engine?

petrol oil ratio for mercury 80 horsepower boat engie

How to start my Iveco 35/10 van?

After fitting a 2nd hand turbo & lifting the top plate off the injection pump than replacing it I can not star... [Read more]

starting mountfield empress 16?

My empress 16 with Tecumseh engine is starting on the pull but dying away when the fuel in the carb is burned ... [Read more]

Engine dies when clutch is released?

I have a craftsman riding mower with a b&s 14.5 engine. The mower starts fine however when I release the clut... [Read more]

running problems on saxo 1.1 v reg?

hi, can anyone help i own a saxo and as i accelerate through all gears on occasions the engine dips as if to s... [Read more]

Does anyone know anything about the mazda 121?

I've had a 1996 mazda 121 for about 4 months now and recently its problem has gotten worse. i will be driving ... [Read more]

Oil in the carberator and engine has white smoke coming from it?

What is wrong with my 10.5 Briggs and stratton motor when I have oil in the carberator and having white smoke ... [Read more]

what are the torque settings for a fiesta zetec big end bearings?

it is for a 2003 model 1.4 engine

how can i fix the loss of drive at the cutting end ?

mculloch tm210 will not turn at the blade end just idle's round, engine run's fine.