How to mend ... G After Changed

Wrinkles?

My EasyLam II is producing wrinkles when I laminate. I recently changed rolls and since, it doesn't laminate ... [Read more]

Advice on mk 7 transit?

Front am back side lights not working on one side changed builds checked fuses all seem to be fine any ideas p... [Read more]

Loud noise on white knight 77aw condenser dryer.. not bearing?

Hi Really need some help. We have had the bearing changed and still sounds like a tank!! Sounds to be coming ... [Read more]

problem with tv?

my tv loses the picture every 20 mins est. The sound is still on but no picture. I have changed all the leads... [Read more]

My light bulb is not working in my hotpoint ff187e fridge freezer, ?

My fridge light is not working on my hotpoint ff187e fridge freezer, I've changed the bulb but it's still not ... [Read more]

Worcester 24i combination boiler pressure loss?

Had fan changed, PCB board changed, internal blockage due(manifold changed) water pressure sensor changed. N... [Read more]

I have a no start issue?

Hi I'm busy with a 2004 e46 320d, the previous guys changed the motor and now it does not start. I have run an... [Read more]

i have a ford focus cmax 2004 the fob was low so i changed the battery and ?

i can open the drivers door with the key but the engine will not start the car is a ford focus cmax year 2004

2007 Ford Focus message centre displaying strange codes ?

My message center randomly changed one day when I turned the car on to the following SNI .0 EVA 32 TUO 66 ... [Read more]

I've replaced the thermostats and heater plate?

I have a hot point Aquarius condenser tumble dryer tdc32 It started blowing cold air so I presumed it would b... [Read more]

How can I fix Renault kangoo 1.9 van x reg?

Renault kangoo 1.9deisel van x reg. glow light NOT showing on dash board and won't start. Changed relay Uni... [Read more]

Indicators have stopped working?

I have 03 2.2 Citroen relay and the indicators and hazards have stopped working, changed the stalk and hazard ... [Read more]

my rover 45 02 plate heater blower does not work in any settings?

I have changed the resistor pack and still does not work. Any further suggestions other than a new/second hand... [Read more]

Siemens rdj10rf thermostat clock?

I have the Siemens rdj10rf thermostat clock and receiver. I changed the batteries on the thermostat, I pressed... [Read more]

worcester oil heatslave 20/25?

worcester oil heatslave 20/25 combi boiler has stopped working, its like no power is going to boiler, have cha... [Read more]

Problems after a power cut?

The keypad tones have changed The outside bell box blue light is flashing The outer hall sensor picks you up... [Read more]

Stannah stair lift 260?

Please my stannah stair lift 260 keeps stopping stops for around 2days and then works again for around 2days b... [Read more]

Hands are moving very fast on wall clock?

I have an Equity 40222S 10 inch Insta Set Analog Clock which worked fine, but then the second and hour hands b... [Read more]

Beko wma 642 no power changed plug?

Beko wma no green light or power

colours are all wrong?

epsonstylus photo r360 changed cartridge printing ok but colours all wrong