How to mend House Lights Alarm

1

How to turn of tamper alarm on Logic Six house alarm?

I moved into the house over 2 years ago and have never touched it nor do I have a fob. It's never done anythin... [Read more]

1

House alarm Scantronic 9427?

Scantronic 9427 panel has no lights. Replaced three fuses in inside metal case and also fitted new battery. St... [Read more]

2

Scantronic 9800 problem?

Hi, this morning I unset my alarm (28 years old) and as I am doing some electrical work in the kitchen, I need... [Read more]

1

All lights on TS510 small control panel in garage?

I switched off mains electricity to replace kitchen socket. When I turned on the elec again all led lights hav... [Read more]

1

veritas alarm cannot be reset or accepts code?

I had to disconnect power on house electrical board in order to fit new sockets switches and dimmer switches f... [Read more]

1

Vertitas 8C alarm - internal battery keeps dying?

Hi I have a Veritas 8C alarm in my house which was installed prior to moving into the property 4 years ago. ... [Read more]

7

Accenta 8 outside siren not working?

We recently had some painting work done to the outside of the house and the contractor (bless him) silenced th... [Read more]

1

Scantronic 9800?

I have a house alarm controlled by a Scantronic 9800 key pad. When the alarm is set and all doors closed, the ... [Read more]

1

Scantronic 9454 - tamp/fault/service?

Hi Just moved into a new house and when electrician was installing a new consumer panel, he removed the fuse ... [Read more]

2

Red light stays on 1 of the PIR's (Veritas 8 system)?

Hello Hope someone can please help. We have recently moved house and there is a Veritas 8 alarm system fitted... [Read more]

3

Scantronic 9827 resetting problem?

I have a Scantronic 9800+ house alarm with 9827 keypad. Although the alarm was not set, at 0400 today the ala... [Read more]

1

Accenta6 home alarm?

Hi, the bathroom wiring was damaged but unfortunately the plumber has chased into the wall and is now covered ... [Read more]

1

Home alarm systems?

Following a power cut our Cooper Menvier 9427 panel has no lights on left hand side on the operating control p... [Read more]

8

C&K active 5 failure?

I came home yesterday evening and noticed the strobe on the bell box flashing but no alarm,on entering the hou... [Read more]

3

mykeypad lights up but there is no power light. I cannot set my alarm. ?

My keypad lights up, but there is no power light. I am unable to set my alarm. It was fi e a few weeks ago. An... [Read more]

5

iSOLATE c & k st800L?

I bought my house 3 years ago, no code (previous owner sadly died) Alarm has stayed silent until power cut yes... [Read more]

2

Optima XM house alarm?

Went to bed last night, did not set alarm but noticed both mains & day mode lights were lit as normal. Went to... [Read more]