how can I fix my Hygena extractor fan APP2410?

I just fixed same problem - lights ok, no motor.

!!! If you're going to attempt this make sure the hood is isolated from the mains !!!

I removed the switch box (remove greasy grilles, remove 2 small screws holding the box in place), and opened it by removing 4 further screws.

There was a burned out solder joint on the PCB which had effectively disconnected power to the switches. I cleaned and repaired it, then refreshed the rest of the solder joints as there were a few others which looked cracked. Mechanical stresses from the switches, I'm guessing.

It's now as good as new! Which is to say noisy and ineffective :D

charlie robson
September 2013

hygena extractor fan 2410 .light works fan not working what could be the problem

brian
February 2011

Mine has just gone. Took out PCB Board (switches). The board has melted and was getting hot FIRE!. Smoke was coming from it. New part at Espares.co.uk. £45 (put in code "Newyear2008" get 10% off.

Stinky Pete
January 2008

Clare it is probably the pcb switch , you will need a soldering iron to replace , costs about 44 pound

Andy
December 2007