f28 fault is showing on my vaillant boiler system?

I tried a few times and .F28 . Every time took the front panel off and the big black air inlet pipe was away from the housing popes it back on on and works fine again . Hope this helps

Ady harvey
June 2016

hi i havevaliant boiler turbomax f28 its no flaim

ali
December 2013

just had a plumber out he rang gas company they ran him through what to do can't believe it!

Rachel
January 2013

In my case: (by removing boiler cover) I could see the ignition was trying to light and inside the chamber there was a flicker of gas ignition but not enough to get it going. I simply covered my outside extractor vent from the boiler as it seemed much of the gas was escaping (I could smell it) and the elements were getting in, possibly blowing the flame out. Try placing a towel over the outlet whilst igniting boiler - it worked for me!

Ben
February 2012

Just experienced the same problem, I spoke to my installer first who told me to try the Hairdring Trick (My Boiler is up in the loft) and it's freezing outside. Warmed up the expansion pipe and hey presto. One thankful and warmer Guy plus don't have to shell out for a callout.

Aid
February 2012

My ecotech has been showing the same fault last few days. It is the condensing pipe running outside freezing (mine is 3m long and runs into my rainwater pipe.
Hacksawed it of tonight, so the excess water drips on the floor. Problem seems to be fixed

steve burrows
December 2010

I get a red light witha f.28 error.
With particularly cold external conditions, the plastic pipe from the boiler to the outside may have frozen solid. I would heat the pipe slowly using a hair dryer freeing the drain ice from the pipe. When you are sure it is clear, press the ignition button under the red light and it should fire the boiler up without any problem.

Peetie
December 2010

F28 is gas supply or ignition problem. Sorry cannot help further than that.

Kal
November 2007

Hi,

I get a red light witha f.28 error.

I use a screw driver and turn the value on the far right beneath the boiler. The pressure level goes up and then turn the value again to stop water flow. Then press the button below the red light, (this is on my boiler not sure abt urs), the button has a flame icon on it.

BUT IT DOES KEEP RECURRING.

Hope this help.

MANSOOR.

MANSOOR.
September 2007