blomberg washing machine dose not spin?

Also fixed my Machine using Jimmy The Hoover tip. Nice one!

BrianM
October 2010

I have carried out Jimmy the hoover process and hey prestro it worked. So thank you for your help.

Steve
February 2010

you have a faulty module on your timer or oneof the componentis faulty. can repair at the shop.

anjum zaman
October 2007

Switch Off Power to washing machine and unplug.

Gain access to rear of machine. Looking into the back of machine, to the lower left of the driven drum wheel (large one), see a small plastic bottle with a rubber tube leading from it and going behind the wheel, up to a round plastic unit situated in the top corner of the machine body.

Remove the plastic bottle by pulling it from it's seating. Remove rubber pipe from bottle.

Check bottle for build up of scum and clean out thoroughly. Clean out the hole where the bottle fits into the back of the drum. Blow, very gently, up the rubber pipe and note if you hear a clicking (switching) noise. Replace the bottle (press fit) and reconnect the rubber pipe (making sure there is clearance between it and the wheel/belt.

Replace covers, restore power and give it a try!

This is a common fault on this machine, the build up of scum in the bottle prevents the vacuum switch from operating, with water induced pressure, and doesn't make the spin circuit. The machines 'mind' thinks it is still full of water.

Jimmy the Hoover
July 2007

check that the presure chamber on the back is not blocked as this stops them from spinning

airkool@hotmail.co.uk
July 2007