Indesit WIDL126s washer/dryer "easy Iron" and Door lock LED's flashing?

I had the same problem. I read on another website that, although this is caused by the pressure switch, often it does not need replacing, there is a reset procedure that they don't tell you about in the instruction book. First, check all the hoses are OK and not kinked. Clean out the filter behind the front bottom panel, just in case. Then, switch on the power, set a program, and press AND HOLD the start button for 30 seconds. This worked for my machine!

Spyke Golding
September 2007

widl codes - light flashing from left to right are numbers 1-4

f01 light 4, motor triac
f02 light 3 motor, jammed/ tacho
f03 lights 3&4 Ntc fault
f04 light 2. pressure sw stuck on empty
f05 lights 2&4, pressure sw stuck on full
f06 lights 2&3, N/A?
f07 lights 2&3&4 heater relay
f08 light 1. heater relay
f09 lights 1&4 eprom/setup error
f10 lights 1&3, pressure switch not sensing
f11 lights 1&3&4, pump/draining error
f12 lights 1&2, communication error
f13 lights 1&2&4, dryer ntc/ fan motor
f14 lights 1&2&3, dryer heater
f15 lights 1&2&3&4, dryer heater relay
f16 N/A
f17 light 4, door lock
f18 light 3 comms error (3 phase motor) power board

f1 and f17 share the same light
if its acircuit board fault try these
http://www.freewebs.com/cbrsleeds

phil grimshaw
June 2007