lights up but wont go any ideas?

tony tell me,is every fault on hotpoints the main module??wont pump water out,the main module,wont start the main module,your a joke mate,i have been in the trade for 40 years and never heard such drivel listen folks don't listen to this guy call an agent out or hotpoint but not this guy ,look up his older posts every fault is the main module

gts
November 2014

This is the classic fault if its a Hotpoint machine. Change the main module and it will be fine. We stock them at 56.28 + 6.00 postage. www.emwelec.co.uk or call us on 01159652118

Tony
November 2014

Then the water inlet solenoid valve very probably needs replacing - a relatively easy job. Youtube has videos...

Power off - Lid off - turn off water - remove electrical connector(s) - disconnect external inlet pipe and internal hose - couple of screws - then put the new one in - 10 minutes.

Or call in a specialist ££££

Good luck...
November 2014

it sometimes fills up then its away but wont do that now

leejan
November 2014

Does water enter the machine?
It needs water in it before it begins...

Laurence Llewelyn Bowen
November 2014