How can I fix Renault trafic van rear brake caliper piston?
replaced the rear discs on my trafic van, with new pads I had to adjust the piston position on caliper clockwise to screw in, however, piston rotates but doesn,t screw in any ideas
thanks
I applied pressure with a gclamp while winding clockwise with soft jawed grips
Richard
June 2014
Thanks guys
I didn't like the condition of the calipers replaced them with new all back on and bled great.
Scotty dog
March 2013
Thanks cdc and Kash for that will get to it in the morning
I didn,t realise there was a tool set for this operation that will teach me. will reply tomorrow with result. regards
scotty dog
March 2013
also best to open the brake fluid nipple on the caliper. this will make it easier to get the piston back. otherwise its alot harder. and u will need to turn it anti clockwise at it winds forward clockwise
kash
March 2013
Thanks cdc
Drivers side rear, went to screw anti clockwise, but it was screwing out,returned to screwing clockwise but remains out.
perhaps I need to apply pressure to end of piston while screwing clockwise, using the tool from my dewalt hand grinding wheel .
Thanks
scotty dog
March 2013
If you have the correct wind back tool then it should apply a slight pressure while screwing in,also, not too sure about Renaults but sometimes the o/s is clockwise and n/s screw in a/clock on some models,good luck
cdc
March 2013
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
