AEG Favorit 65050 VI integrated dishwasher - Not heating the water?

Ok - tested the element and the reading across the terminals is 27 ohms - element is ok - any other suggestions gratefully recieved

Kenny Riley
November 2012

Sorry for not getting back sooner but thanks guys for the advice - been away for a bit but hopefully now I will be able to get stuck into the machine and get it fixed!!

Kenny Riley
October 2012

test element with a multimeter across the 2 terminals.29 ohms or there about is good.Also check relay output on main control pcb as they can get bad solder joints and blown tracking.resolder heater relay whilst in there even if it looks good and retry

CK
October 2012

its good that its only the element that has gone, because if it was some other main part , it might cost a lot to fix, i would say its 99% the element that has gone, you need to take out the machine out" take the back off . follow the powers wires in " they should take you to the element, take a photo of the 3 wires that go to it, unscrew the element,, take the 3 wires off, and take it out, replace it, get one the same shape and power rateing> Ebay or a good hardware store, have all power off going to the machine when working on it,as you know, not realy a hard job, once you can get to the element,,

k
October 2012