Hotpoint WMD960P Leak?

Hi all, Firstly, make sure the inside of the dispenser housing is clean, secondly, you could try dropping the front feet a little to lift up the front so the appliance is not leaning forwards, the known cure is to buy a new dispenser drawer, the later ones are modified in that they have an extra strip of plastic moulding underneath to prevent water running out of the front of the drawer and behind the front panel onto the floor, it usually leaks on the left hand side and almost always on the last rinse. I think the part no for the drawer is c00281253. Best to but it from the manufacturer as otherwise you may buy a new (old) design, the same as the one you are replacing. This will solve 99% of unexplained leaks.

Knowitall
May 2012

Hi Richard I have the same problem, there is nothing wrong with the seals etc either, have you solved your problem

Tracy
April 2012

Yeah thanks I have done, any other suggestions welcome.

Rich
April 2012

check the pump hose and fittings on the rubber tubes, make sure there tight,

k
April 2012