how to fix v fit treadmill?

Hi
I have a V FIT C710BF21EB4-E9 tread mill .
just beeping up on control panel and - lines on control panels.

dermot kelly
September 2016

I have the v fit 2510. I haven't used it for some time, I've tried to turn it on but nothing is working. What can the problem be?

Lola
December 2013

Our V-fit treadmill showed 'error 6' and wouldn't function. We took the top casing off (having unplugged the treadmill first) and found the inside clogged with dust. We cleaned it with a soft tool attachment on the vacuum cleaner, put it back together and now it's fine.

Ann
March 2013

Problem with Treadmills

I have a v-fit PST-04 treadmill, model no DK 2510. When I switch it on and try and use it, it comes up with the Error Code E1 what does thos mean




.

.Solutions (2)
Most E1 codes are speed sensor or no belt movement.
You wil lneed to unplug your unit the remove the motor shroud then plug unit in most Motor Control boards have LEDs. First thing I would do is start the unit look down at the board one of the light should start flickering this is a signal being sent to the lower board from your upper console. This tells me that the upper console and cable connecting the upper and lower boards is working also notice if the drive motor moved if not then E1 will come up. Now turn your unit off then turn back on to reset , next manually push with one of your feet the belt you should notice another flickering light the faster you push the light will flicker faster this tells me that the speed sensor is working if not replace the speed sensor. Next procedure check the motor using a fully 18v drill battery or car battery which ever is handy connect the two motor leads usually red and black in some cases black and white to the battery, if the motor move at a speed of approx. 1 mph then you have a good motor if not you can have worn motor brushes or open winding the motor.
If the upper board and drive motor are good then the only thing left is the motor control board if you have a multi meter handy connect the lead to the two spades that motor lead came off of the press start you should get a DC voltage of about 5 to 10V DC if not replace the board.


By John Mazmanian May 31, 2010

john
March 2012