ensure you mark front part of shaft in relation to rear part,[before removing[, i dont think the master spline is very obvious but will cause problems if not lined up!!!
k
February 2011
remove 4 bolts at g/box,2- 9/16 bolts on centre bearing,drop down and slide off splines to separate front from rear,at c/brg there is a 11/16 bolt with locking tab holding yoke on to shaft,remove this to gain access to bearing removal,if you dont have a press a 2lb hammer and chisel can remove the bearing,remember which way it comes off and refit in reverse,good luck
cdc
February 2011
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix vans.