how do I cange a Ford Mondeo front nearside wheel bearing?

you need to take the hub off by undoing drive shaft nut then bottom ball joint pin then drag link end ( end of steering that bolts to hub )then take bolt out that holds suspension leg in take brake caliper off and disk then disconnect wiring to abs sensor separate it all then take hub to engineering firm that has a press to push old bearing out and press new 1 in ( dont try knocking out and in with hammer you just damage new bearing putting in) then reasemble in reverse ,on a not if attempting to do it yourself spray WD40 over nuts and bolts night before doing cheaper and better way is buy a hub from nearest scrapyard and fit that

peesian
April 2010